User manual ROLLS RS79B

[. . . ] Products returned to us or to an authorized Service Center must be accompanied by a copy of the purchase receipt. In the absence of such purchase receipt, the warranty period shall be one (1) year from the date of manufacture. This warranty shall be invalid if the product is damaged as a result of defacement, misuse, abuse, neglect, accident, destruction or alteration of the serial number, improper electrical voltages or currents, repair, alteration or maintenance by any person or party other than our own service facility or an authorized Service Center, or any use violative of instructions furnished by us. [. . . ] NOTE: If the rear panel Frequency Select switch is set for 9kHz, the band will indicate MW 1 and MW2 instead of AM1 and AM2. Indicates a locked signal and stereo operation. If this light is out, the unit is operating in mono or the station is weak. C: Lock indicator - if lit the RS79b is locked onto a station. D: Station frequency indicator E: Indicates whether the station frequency is AM (KHz), or FM (MHz) F: Preset number - 1 - 6. · Power Switch: Applies power to the RS79b. IMPORTANT NOTICE: IF THE POWER IS TURNED OFF BY THE REMOTE, THIS FRONT PANEL POWER SWITCH IS INOPERABLE UNTIL THE 2 REMOTE IS USED TO TURN THE POWER BACK ON. DESCRIPTION CONT. · AM reception may not be possible without the loop antenna attached. Even if an outdoor antenna is connected, keep this loop antenna in place. · Do not bring the power cord or speaker cords near the loop antenna. Interference or noise will be generated. Multipath reflections FM waves, like light waves, travel in a straight direction unless reflected off objects in their path. Because of this, two sets of waves reach your antenna from the FM station; those that have traveled directly to the antenna, and those that have been reflected off buildings or mountains. When the antenna receives both kinds of signals, the two interfere with each other and result in distorted sound and poor separation. This phenomenon is called "multipath reflection". To reduce this problem, select an antenna with good directivity and place it in the best location with strong reception. · AC: Three connector power cord. [. . . ] Using either the SCAN/UP, SEEK/UP, TUNE +, or TUNE buttons - select the station you wish to program. To store that station in a preset (M1 - M6), press and hold the desired preset button until the CH # appears in the display. For example, once you've selected the desired station, to store that in preset M3, press and hold M3 until a CH 3 appears in the display. [. . . ]