User manual ROSE DISPLAYS ANOFRAME ROUND WITH 4 WALL MOUNTS

[. . . ] AnoFrameTM Round Profile Instruction Sheet Parts Corner Brackets AnoFrame Rails 12AF-100 AnoFrame Split Rails Wall Mounting Hangers 06-6067 Instructions For Hanging solid rail Step 1 Locate the two split rails and the solid rail that is the same length as the split rails. Insert corner brackets into side AnoFrame rails. [. . . ] 4 Step 4 Slide AnoFrame onto wall mounting hangers. Step 5 split rails Figure 1 solid rail Figure 2 split rails solid rail Figure 3 Figure 4 Install bottom mounting hangers. Fig 7 Note: The AnoFrame shown here is a round profile. It is available in either square or round profile. Figure 5 Figure 6 Figure 7 The AnoFrame is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoFrame4Hangers Incept-8. 15. 02 35 Congress Street, Salem MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoFrameTM Round Profile Instruction Sheet Parts Corner Brackets AnoFrame Rails 12AF-100 AnoFrame Split Rails Wall Mounting Hangers 06-6067 Instructions For Hanging solid rail Step 1 Locate the two split rails and the solid rail that is the same length as the split rails. Insert corner brackets into side AnoFrame rails. Insert two corner brackets into each end of the solid side Ano rail. Insert one corner bracket into each end of each split side Ano rail. 2 Note: Tension tabs on corner brackets face towards outside of frame. Step 2 Finish assembling frame by following sequence in Fig. Step 3 Install wall mounting hangers using a Phillips head screwdriver. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoFrame4Hangers Incept-8. 15. 02 [. . . ]