User manual ROSE DISPLAYS ANOFRAME SQUARE WITH 2 WALL MOUNTS

[. . . ] 2 Note: Tension tabs on corner brackets face towards outside of frame. 1 Figure 1 Figure 2 split rails Step 2 For ceiling application, slide screw tabs into channel of top Ano rail. For wall applications, slide into side Ano rail. [. . . ] For wall applications, slide into side Ano rail. 3. Step 3 Place one transitional collar over each screw tab and push onto frame. 4. Figure 3 Figure 4 solid rail Step 4 Finish assembling frame following the sequence in Fig. Note: Placement of split rails will depend on type of frame. Split rails will be on the top for top-loading frames and on the side for sideloading frames. solid rail split rails Figure 5 The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSVersaMountScrewBaseSQ Incept-9. 06. 02 35 Congress Street, Salem MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoFrame VersaMountTM Screw Base #97-0451SQ Parts Instructions For Assembly Step 5 Screw posts onto screw tabs and tighten. 4. Figure 3 Figure 4 solid rail Step 4 Finish assembling frame following the sequence in Fig. Note: Placement of split rails will depend on type of frame. Split rails will be on the top for top-loading frames and on the side for sideloading frames. solid rail split rails Figure 5 The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSVersaMountScrewBaseSQ Incept-9. 06. 02 AnoFrame VersaMountTM Screw Base #97-0451SQ Parts Instructions For Assembly Step 5 Screw posts onto screw tabs and tighten. 6 Note: Use the end of the post with the smaller opening. Instruction Sheet (page 2 of 2) Step 6 Insert one screw into the middle opening on each screw base and into the post. 8 Figure 6 Figure 7 Step 7 Install screw bases using wood screws and screwdriver. [. . . ] 6 Note: Use the end of the post with the smaller opening. Instruction Sheet (page 2 of 2) Step 6 Insert one screw into the middle opening on each screw base and into the post. 8 Figure 6 Figure 7 Step 7 Install screw bases using wood screws and screwdriver. 9 Note: Togglebolts are recommended for drywall installations (predrilling 3/8" holes is necessary) Figure 8 Figure 9 Step 8 Slide your graphic into the AnoFrame. [. . . ]