User manual ROSE DISPLAYS ANOFRAME SQUARE WITH CABLE CLIP AND BALL CHAIN

[. . . ] AnoFrameTM Parts Instruction Sheet Ball Chains 96-0302P Corner brackets AnoFrame rails 12AF100 AnoFrame split rails Cable Clips 06-5050 Instructions for assembly Step 1 Insert corner brackets into vertical AnoFrame sides. Note: Assembly brackets tension tabs face towards outside of frames. [. . . ] Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Figure 3 solid rail w/ Figure 4 split rails Step 4 Assemble frame following steps in. 5 sliding sides together in the order shown. 3 solid rail 4 Step 5 Insert poster. Fig 6. The AnoFrameTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoFrameCableClipBallChain Figure 5 Figure 6 Incept-9. 24. 02 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoFrameTM Parts Instruction Sheet Ball Chains 96-0302P Corner brackets AnoFrame rails 12AF100 AnoFrame split rails Cable Clips 06-5050 Instructions for assembly Step 1 Insert corner brackets into vertical AnoFrame sides. Note: Assembly brackets tension tabs face towards outside of frames. Split rail side is made up of 2 separate pieces. 1 2 split rails solid rail Step 2 Insert single ball of ball chain into inner channel of Cable Clip. 3 Figure 1 Figure 2 Step 3 Align one round end of cable clip with top channel of the aluminum rail and insert. Once in place, insert end of ball chain into channel. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoFrameCableClipBallChain Figure 5 Figure 6 Incept-9. 24. 02 [. . . ]