User manual ROSE DISPLAYS ANOFRAME VERSAMOUNT CLAMP BASE SQ

[. . . ] AnoFrame VersaMountTM Clamp Base #97-0421SQ Parts Instruction Sheet (page 1 of 2) AnoFrame Rails AnoFrame Split Rails Corner Brackets Screw Tab Transitional Collar Vertical Post Clamp Base Instructions For Assembly solid rail Step 1 Locate the two split rails and the solid rail that is the same length as the split rails. Insert corner brackets into side AnoFrame rails. [. . . ] Part #02INSVersaMountClampBaseSQ Incept-9. 6. 02 35 Congress Street, Salem MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoFrame VersaMountTM Clamp Base #97-0421SQ Parts Instructions For Assembly Step 5 Screw vertical post onto screw tab on frame and tighten. 6 Note: Use the end of the post with the smaller opening. Instruction Sheet (page 2 of 2) Step 6 Screw the clamp base onto the end of the vertical post and tighten. Fig 7 Figure 6 Figure 7 Step 7 Slide your graphic into the AnoFrame. 8 Figure 8 Finished Look The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSVersaMountClampBaseSQ 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-9. 6. 02 AnoFrame VersaMountTM Clamp Base #97-0421SQ Parts Instruction Sheet (page 1 of 2) AnoFrame Rails AnoFrame Split Rails Corner Brackets Screw Tab Transitional Collar Vertical Post Clamp Base Instructions For Assembly solid rail Step 1 Locate the two split rails and the solid rail that is the same length as the split rails. Insert corner brackets into side AnoFrame rails. Insert two corner brackets into each end of the solid side Ano rail. Insert one corner bracket into each end of each split side Ano rail. 2 Note: Tension tabs on corner brackets face towards outside of frame. Figure 1 Figure 2 split rails Step 2 Slide screw tab into channel of bottom Ano rail. 3. Step 3 Place transitional collar over screw tab and push onto frame. 4. Figure 3 Figure 4 solid rail Step 4 Finish assembling frame following the sequence in Fig. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSVersaMountClampBaseSQ Incept-9. 6. 02 [. . . ]