User manual ROSE DISPLAYS ANOKIOSK WITH BASE RAIL

[. . . ] AnoKioskTM Parts Instruction Sheet Bottom Rails with Base Rail Kiosk spine 06-2175 Corner brackets 1a Single rails 1b Split rails Instructions for Assembly Note: We recommended that two people assemble this kiosk. Step 1a Slide spine into vertical rail. Step 1b Slide another vertical rail onto the other edge of spine. Repeat for all vertical rails and spines. 2a 2b Step 2 Carefully insert corner brackets into ends of bottom rails, using thumb as shown in illustration. [. . . ] Note: (4 way only) The last vertical rail will be tensioned. This is normal. 5 4-Way 3-Way 6 Step 5 Insert corner brackets into ends of split rails, 1 per end. Use thumb as shown in illustration. Step 6 Assemble split rails onto top ends of vertical rails, one inside and one outside of each side of the AnoKiosk. 7 Step 7 Insert and change signs through top of each side. The AnoKioskTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoKioskRigidBase Rail 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-09. 20. 02 AnoKioskTM Parts Instruction Sheet Bottom Rails with Base Rail Kiosk spine 06-2175 Corner brackets 1a Single rails 1b Split rails Instructions for Assembly Note: We recommended that two people assemble this kiosk. Step 1a Slide spine into vertical rail. Step 1b Slide another vertical rail onto the other edge of spine. Repeat for all vertical rails and spines. 2a 2b Step 2 Carefully insert corner brackets into ends of bottom rails, using thumb as shown in illustration. Detail- It is important that the corner bracket tension tab faces toward outside of frame. (2b) (Continued on other side) The AnoKioskTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoKioskRigidBase Rail Incept-09. 20. 02 AnoKioskTM Step 3 Lay out the bottom rails on the floor as they will be configured. Instruction Sheet (side 2) 3 4 Instructions for Assembly continued Step 4 Assemble the vertical rail assemblies onto the upward facing corner brackets already inserted into the bottom rails. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoKioskRigidBase Rail Incept-09. 20. 02 [. . . ]