User manual ROSE DISPLAYS ANOQUICK ROUND WITH CABLE AND CRIMP SLEEVES

[. . . ] AnoQuickTM Instruction Sheet Parts Crimp Sleeves 80-0101 AnoQuick 12A300 MultiClips 1UP-0100 End Caps 06-5525 Cable and Ball 16-0018B Instructions For Hanging Step 1 Prepare edges of graphic. Place the graphic on tabletop with one edge at the table edge. [. . . ] 4 Figure 3 Step 4 Use Crimp Sleeves to form a loop to secure the cable to the MultiClip. 5 Use pliers to crimp the sleeve securely to form the loop. Trim any excess cable after crimping. Figure 4 Figure 5 Step 5 Push end caps into place. 6 Figure 6 Important note: Please save and reuse the AnoQuick Holder, End Caps and MultiClips for future projects. The AnoQuick is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoQuickLoopBall Incept-8. 15. 02 35 Congress Street, Salem MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoQuickTM Instruction Sheet Parts Crimp Sleeves 80-0101 AnoQuick 12A300 MultiClips 1UP-0100 End Caps 06-5525 Cable and Ball 16-0018B Instructions For Hanging Step 1 Prepare edges of graphic. Place the graphic on tabletop with one edge at the table edge. Using the AnoQuick Holder, run it across the graphic edge, crushing it slightly. 1 Step 2 Starting at one corner, push the holder onto the graphic. Work your way down the holder tapping it down firmly to seat the graphic fully. 2 Figure 1 Figure 2 Step 3 Slide MultiClip into top of AnoQuick Holder. Holding clip at slight angle, first insert one round end, then press down on other round end and push MultiClip into holder. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoQuickLoopBall Incept-8. 15. 02 [. . . ]