User manual ROSE DISPLAYS ANOQUICK WITH PEG

[. . . ] AnoQuickTM with Peg Instruction Sheet Parts AnoQuick 12A300 Pegs 06-1920 Instructions for Hanging Step 1 When using AnoQuick to hang 1/8" Sintra or an equally heavy substrate, have your printer punch two 1/4" holes along the top and bottom edges of print -- or only the top if no bottom holder is being used. [. . . ] 3 Note: This is the easiest way to safely hang heavier substrates. Figure 3 The AnoQuick is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part # 02INSAnoQuickPeg 35 Congress Street, Salem, MA 01945 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-9. 9. 02 AnoQuickTM with Peg Instruction Sheet Parts AnoQuick 12A300 Pegs 06-1920 Instructions for Hanging Step 1 When using AnoQuick to hang 1/8" Sintra or an equally heavy substrate, have your printer punch two 1/4" holes along the top and bottom edges of print -- or only the top if no bottom holder is being used. 1 Note: Each hole must be centered 1/4" in from the edge of the substrate. Figure 1 Step 2 Push both parts of the peg together through each of the punched holes. 2 Figure 2 Step 3 Slide AnoQuick onto substrate. The pegs should slide into the side rails. [. . . ] Part # 02INSAnoQuickPeg Incept-9. 9. 02 [. . . ]