User manual ROSE DISPLAYS ANOSCREEN WITH VARIO BASE

[. . . ] AnoScreenTM Parts Instruction Sheet Ano rails Vario Base Corner Brackets Vertical Rails with Flex Spine Split Rails Instructions For Assembly Step 1 Insert corner brackets into ends of bottom rails, using thumb, as shown in illustration. 1a- Corner bracket tension tabs face toward outside of frame. 1 1a Step 2 Snap base Ano rail sections into the Vario base section. [. . . ] Start at one end and work the Vario base onto the Ano rail. 2 2a Step 3 Lay out parts as they will be configured on the floor. (2, 3 or 4 panels) 3 3 2a 2 Panel 3 Panel 4 Panel (continued on other side) The AnoScreenTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoScreenVario. Incept-8. 15. 02 AnoScreenTM Instruction Sheet (side 2) Instructions For Assembly Continued Step 4 Assemble the vertical rail assemblies onto the upward facing corner brackets already inserted into the bottom rails. All 4 brackets can go into the vertical rails at one time, or you cando one side at a time. Note: Make sure grommets are on the top end of the vertical panels. Use the two vertical rails without flex spine connectors on the outside edges of the outermost panels. 4 5 6 Step 5 Insert corner brackets into ends of split rails, using thumb, as shown in illustration. 1bracket per end of each split rail. Step 6 Assemble split rails onto top ends of vertical rails, one inside and one outside of each panel of the AnoScreen. 7 Step 7 Insert and change signs through top of each panel. Corner brackets & Split Rails Vario Base The AnoScreenTM is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoScreenVario. Incept-8. 15. 02 35 Congress Street, Salem, MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoScreenTM Instruction Sheet (side 2) Instructions For Assembly Continued Step 4 Assemble the vertical rail assemblies onto the upward facing corner brackets already inserted into the bottom rails. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoScreenVario. Incept-8. 15. 02 [. . . ]