User manual ROSEN M10 REV B

[. . . ] 10. 2" Widescreen Monitor/ Dual-Zone System Controller Owner's Manual NOTICES NOTICE OF INTENDED USE Rosen Entertainment Systems are designed to enable viewing of video ONLY for rear-seat occupants, and are not intended for viewing by the driver when the vehicle is in motion. Such use might distract the driver or interfere with the driver's safe operation of the vehicle, and thus result in serious injury or death. Such use might also violate state or local laws. Rosen Entertainment Systems disclaims any liability for any bodily injury or property damage that might result from any improper or unintended use. Table of Contents Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] These headphones allow rear-seat passengers to listen without using the vehicle speakers. To turn the headphones on and off, push the Power ON/OFF button on the right ear piece. The Power LED on the left ear piece indicates when headphone power is on. Power turns off automatically after three minutes of no audio, in order to preserve battery life. To adjust the headphone volume, rotate the thumb wheel on the headphones. To adjust the headphone size for differently-sized heads, slide the top as needed. Adjust headphones here REPLACING HEADPHONE BATTERIES The wireless IR headphones require two AAA batteries. To replace the batteries, slide off the battery compartment door on the right earpiece and insert batteries, as shown. Make certain that the battery orientation matches the marks inside the battery compartment. Power ON/Off switch USING OPTIONAL WIRED HEADPHONES There is a jack for wired headphones on the forward edge of the unit, under a removable cover. When using optional wired headphones, only use headphones with a volume control, since the system has no volume adjustment. Volume Knob Power LED The M10 IR transmitter has two output channels, A and B. Using A and B, the M10 can transmit two different audio programs at the same time. When using optional Rosen AC3072 dual-channel headphones, listeners can switch between Channels A and B. When the M10 is installed as a second display for a Rosen A10 system, the A10 is the infrared transmitter for both Channels A and B, and the M10 infrared transmitter is disabled. Mini-stereo Headphone Jack 14 Rosen Entertainment Systems LISTENING OVER THE CAR SPEAKERS The M10 uses an FM Modulator (FMM) to send audio through the vehicle radio and speakers. To listen over your speakers: 1 Make sure system MUTE is off. (If "SPEAKER SOUND DISABLED" appears, select an FM frequency as described below. ) 2 Turn on the car radio. Tune to the FM frequency displayed on the screen, such as "FM 87. 7". 3 If no system audio is heard, try changing the FMM frequency and re-tuning the radio to the new frequency. To change the FM Modulator frequency: Press SPEAKER. Now use the Left and Right buttons to change the frequency. The FMM frequencies are 87. 7, 87. 9, 88. 1, 88. 3, 88. 5, 88. 7, 88. 9, 106. 7, 106. 9, 107. 1, 107. 3, 107. 5, 107. 7, and 107. 9. After you select a frequency, re-tune your radio and check for clear sound. The system saves the frequency you select, and returns to it each time the system is turned on. You may want to store the FM Modulator frequency as a preset of your radio for ease of use. [. . . ] If the voltage or temperature goes beyond the limits, the system shuts off. The power wire or power harness may have been disconnected, or the fuse may have failed. Contact your Rosen authorized dealer to determine if this is the case. WHY DO I GET NO RESPONSE WHEN I PRESS THE REMOTE BUTTONS? [. . . ]