User manual ROSENLEW RL520

[. . . ] The minibar is not suitable for the proper storage of medications. The miniBar must be installed in such a way that accidental contact with the cooling unit (which heats up when in use) is impossible. The appliance has to be connected to a properly earthed socket in line with the relevant valid country regulations. Servicing must only be carried out by authorised service personnel. 2. 2 Coolant Ammonia is used as a coolant. [. . . ] Ventilation grills, if used, must have openings of at least 200cm² each. The mains plug/socket must be freely accessible once the miniBar has been installed. 5 4. 6 Securing When being built into a cupboard or a recess, the miniBar must be positioned in such a manner that both hinges/feet of the unit lie flush. The miniBar is then (see Figures a, b) screwed, at its hinges, to the piece of furniture in question. In the case of units with 8mm feet and with LED option for the door opening control, the reflector delivered with the unit must also be installed in the manner shown in Figure a. Stick on supplied reflector. , . . . Drive in the screws and place the caps on. 4. 7 Connecting the Device to the Electricity Supply The device must be connected to a properly earthed socket in line with the relevant valid country regulations. The mains plug/socket must be freely accessible. Check prior to initial operation that the voltage noted on the model label corresponds to the mains voltage. If this is not the case, do not connect the device and contact your dealer!If the connection cable is damaged it must be replaced by the Customer Service at Dometic, or by respectively qualified personnel, in order to prevent any hazards. 6 4. 7. 1 Attention: For GB only ! Plug connection for United Kingdom only If a 3-pin plug is used, it should be fitted with a 3 amp fuse, with other plug types, the circuit should contain a 5 amp fuse. Warning - This appliance must be earthed. IMPORTANT The wires in the mains lead of this appliance are coloured in accordance with the following code: GREEN and YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. Connect the GREEN and YELLOW coloured wire to the plug terminal marked letter E or earth symbol or coloured green or green and yellow. Connect the BROWN coloured wire to the plug terminal marked letter L or coloured red. Connect the BLUE coloured wire to the plug terminal marked letter N or coloured black. Moulded-On Plug Version The mains lead is fitted with a non-rewirable moulded-on plug containing a 3 amp fuse. If the fuse requires replacing at any time, the fuse cover/carrier should be removed using a small screwdriver to level out. The old fuse should be replaced by a 3 amp ASTA approved BS1362 fuse and the fuse cover/carrier must be refitted before the plug is used again. If the fuse cover-carrier is lost, a replaceement can be obtained from the Dometic Service Shops. The fuse cover/carrier must be of the same colour as that of the coloured insert in the base of the plug. In no circumstances must the plug be used without a correct fuse cover/carrier fitted. If the plug supplied on the mains lead is not suitable for the socket in your home, it should be cut off and disposed of safely, or destroyed, to avoid any possible shock hazard resulting from the plug being inserted into a 13 amp socket elswhere in the use. A suitable replacement plug should then be fitted as given above. 7 4. 8 Changing the Sliding Hinge 1. 2. 1. 2. 3. 4. Distance to cupboard door (A) 1. When closed, the cupboard door (A) must not lie against the rest of the surrounding cupboard area (distance 1-2mm). There must be a distance of 6-8mm between the cupboard door and the miniBar. 8 4. 9 Changing the Doorhang (optional) LED door-opening control always opposite the hanging side device with feet LED If the miniBar is equipped with the LED first carry out steps a. : a. Pull out LED, lay the cable into the cable routing and insert the LED at the opposite side. d. d. [. . . ] The cooling unit uses ammonia as the coolant (a natural compound of hydrogen and nitrogen). Cyclopentane, which does not damage the ozone layer, is used as propellant for the insulation made from PU-foam. 5. 12 Disposal In order to ensure the re-use of recyclable packaging materials, these must be disposed of using local collection systems. The device itself must be handed over to a disposal company or local council which will guarantee the correct use of recyclable materials and the proper disposal of the rest. Appliances bearing this symbol must be deposited at the designated local reception point for the disposal of electrical and electronic equipment. It is not permitted that this product be disposed of by way of the normal household refuse collection system. [. . . ]