User manual ROSENLEW RW402

[. . . ] This is a natural compound also used in household cleaning agents (1 litre of Salmiak cleaner contains up to 200g of ammonia - about twice as much as is used in the refrigerator). Sodium chromate is used for corrosion protection (1, 8% of the coolant). If a leak occurs (which can be easily detected due to the unpleasant smell): Switch the device off (pull mains plug, if applicable); Ventilate room thoroughly. For the safety of hotel guests and personnel, it has been established by inspectors that the coolant poses no threat to health. 3. 0 WARRANTY AND CUSTOMER SERVICE Warranty arrangements are in accordance with EC Directive 44/1999/CE and the normal conditions applicable for the country concerned. [. . . ] Ventilation must be provided as shown in alternatives A, B, C or D. The ventilation duct must at least measure 105mm x the width of the refrigerator. Only the entire cooling unit must project into the duct as shown. 6 Air passing through the duct must not be preheated by any source of heat. Ventilation grills, if used, must have openings of at least 200cm² each. The mains plug/socket must be freely accessible once the miniBar has been installed. 5 4. 6 Securing When being built into a cupboard or a recess, the miniBar must be positioned in such a manner that both hinges/feet of the unit lie flush. The miniBar is then (see Figures a, b) screwed, at its hinges, to the piece of furniture in question. In the case of units with 8mm feet and with LED option for the door opening control, the reflector delivered with the unit must also be installed in the manner shown in Figure a. Stick on supplied reflector. , . . . Drive in the screws and place the caps on. 4. 7 Connecting the Device to the Electricity Supply The device must be connected to a properly earthed socket in line with the relevant valid country regulations. The mains plug/socket must be freely accessible. Check prior to initial operation that the voltage noted on the model label corresponds to the mains voltage. If this is not the case, do not connect the device and contact your dealer!If the connection cable is damaged it must be replaced by the Customer Service at Dometic, or by respectively qualified personnel, in order to prevent any hazards. 6 4. 7. 1 Attention: For GB only ! Plug connection for United Kingdom only If a 3-pin plug is used, it should be fitted with a 3 amp fuse, with other plug types, the circuit should contain a 5 amp fuse. Warning - This appliance must be earthed. Insert the hinge pin in the door, push in the door and let the hinge click in. - Remark (devices without doorlock): - Additional installation of a door lock is possible (available from Dometic) - In the door the position for the opening is prepared. - Drill the hole in accordance to the drawing above. 10 5. 0 5. 1 INSTRUCTION for USE Initial Operation The device must be plugged into a properly earthed socket. The miniBar starts automatically with a selftest. If the electronics do not detect any fault, the LED for the interior lighting illuminates for 2 seconds after approximately 10 seconds. If a fault is detected, the illumination changes to a continuous flashing light. If this occurs, please consult your authorised Customer Service. The miniBar achieves its operating temperature after several hours. The miniBar operates silently ! 5. 2 Temperature Control The miniBar is fitted with an electronic temperature control which works fully YELLOW = 3°C automatically. A preadjustment of 3° or 5° is possible by means of an optional remote control. BLUE = 5°C 5. 3 Automatic Defrost Function The first defrosting phase commences 39 hours after the initial operation and lasts for two hours. After this, the device operates for 22 hours at a time, followed by a defrosting period of 2 hours . The ice layer must never be removed using force, nor must the defrosting process ever be accelerated using a heater. 5. 4 Leakage Detection The electronics carry out a leakage test after every defrosting period (every 24 hrs) by measuring the temperature at the evaporator by means of a second sensor. If the electronics detect a leak, the miniBar is automatically switched off . The LED for the interior lighting changes after approx. [. . . ] Possible Cause a. ) The cooling aggregate is not sufficiently ventilated. Self Help a. ) Check that the ventilation grids are not covered. Check that device has been installed properly (installation instruction 4. 5). b. ) Follow installation instruction 4. 5. [. . . ]