User manual ROSIERES 1441

[. . . ] G) This appliance is not intended for use by young children or infirm persons without supervision. H) Young children should be supervised to ensure they do not play with the appliance. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. L) There is a risk of fire if cleaning is not carried out in accordance with the instructions. [. . . ] Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig. 15) so that the unit is easier to handle. We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. Hoodassembly: - Remove the structure from the packaging and remove the 2 screws A to separate the upper part from the lower part (Fig. Make 4, Ø8 holes in the ceiling and drive in 3 screws without completely tightening them. Pay attention not to insert the screw into the hole marked with an X on the hole template (the screws and expansion plugs must be suitable for the type of wall). - Take the upper part of the structure B (Fig. 4) and insert the 3 slots onto the 3 screws that are not completely tightened. Drive in the fourth screw X and tighten the remaining 3 to allow definitive blocking of the upper part of structure B. - Take the lower part of the telescopic structure C and insert it into the upper structure B (Fig. the appliance has already been set for an electric hob by the manufacturer. Intensive: This function allows you to temporarily increase the motor's extraction rate for about 10 minutes. To activate the function, press the "D" button after selecting extraction rate level 3. After 10 minutes, the appliance will return to operate at extraction rate level 3. Timer: This function allows you to set the appliance to run for 15 minutes and then switch off. The timer does not interact with the lights. to deactivate the function , set the extraction rate level back to "0". Clean air: The clean air function allows you to run the appliance for about 10 minutes every hour at the lowest extraction rate level to allow for constant circulation of fresh air. To activate the function, press the "E" button for a few seconds with the motor off. Once the function has been activated, the letter "C" will start flashing on the display. to deactivate the function press the "B+D" buttons together. [. . . ] Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, not-abrasive liquid detergents. The light on the cooker hood is designed for use during cooking and not for general room illumination. Med and how often the anti-grease filters are cleaned. To deactivate this function, press the "A+E" buttons together with the motor off. [. . . ]