User manual ROSIERES C 3050

[. . . ] The hob should be given a quick clean after each use, to avoid the accumulation of spillages and grease. If spillages are not Code: 39354774 -0306 0511 removed, they will harden, and could cause the production of Mod: FE GD21 RB smoke and unpleasant smells. code: 39354774 - 0306 0511 Code: 39354774 Code: 39354774 Code: 39354774 - 0306 0511 - 0306 0511 - 0306 0511 220 - 240 V · When cooking with fats or oils, never leave gas burner unattended. Overheated fats or oils can quickly catch fire. [. . . ] It may be necessary to adjust this regulation according to the conditions of your domestic gas supply. The burner flame should be steady and with no red or yellow points. The air ring is located at the lengthening of the burner unit which is fixed by a screw (see drawing). Set the correct distance according to the air adjuster protrudes, · Fixing screw Fixing Air screw regulation If you have changed the type of gas, it is important to verify the flame stability at the minimum regulation. Turn the by-pass screw until a low flame is visible. Turn the control knob from minimum to maximum position to check that it is satisfactory. B) Butane-propane gas : The by-pass screw should be screwed fully home, without being locked. If they are to be used with another type of gas, the appliance must be adjusted in the following way: Fit the correct jet for the type of gas to be used, · If you have changed the type of gas, it is important to verify the flame stability at the minimum regulation. Turn the by-pass screw until a low flame is visible. Turn the control knob from minimum to maximum position to check that it is satisfactory. B) Butane-propane gas : The by-pass screw should be screwed fully home, without being locked. It will switch off when the temperature of the surface falls below 60° C. Set the flame according to your cooking requirements. Intermediate positions are available between the "+" ( ) and "-" ( ) settings on the control knob. To turn the flame out, turn the control knob back to stop position. If the burner is accidentally extinguished, turn the knob to "0", wait one minute and then try to ignite again. PANS For a proper use of the burners, choose pans which match the dimensions given below : * Double ring Ø 18 cm and more * Very fast Ø 18 cm and more * Fast Ø from 16 to 18 cm * Semi-fast Ø 12 cm · Pans with curved, ridged or warped bottoms are not recommended. These marks can easily be removed with a damp cloth and a light abrasive product. Food is not cooked any more quickly this way. In fact, it is subjected to severe agitation, which may cause the food to lose some of its flavour. To save gas, make sure that the flames do not overlap the bottom of the pan. Do not use the gas burner with an empty pan. [. . . ] mAINTENANCE OF THE VITROCERAMIC or GLASS HOB - Place a few drops of specially formulated hob cleaning solution on the hob surface. - Rub any stubborn stains with a soft cloth or with slightly damp kitchen paper. - Wipe with a soft cloth or dry kitchen paper until the surface is clean. If there are still some stubborn stains : - place a few more drops of the hob cleaner on to the surface, - scrape with a scraper*, holding it at an angle of 30° to the hob, until the stains disappear. [. . . ]