User manual ROSIERES F 254

[. . . ] The unit is secured to the rear panel as though it were being installed on the wall: use the supplied metal bracket (B) and the screws and plugs supplied with the panel. Securing the extension pipes: Basic installation requirements: ­ Set the electrical power supply within the space covered by the decorative piping. ­ If your unit is installed in an Exhaust hood or in a hood with outside motor, prepare the air exhaust hole. When installing exhaust hoods and hoods with outside motor, to achieve the best possible conditions use an air exhaust pipe that: is as short as possible, has a minimum of curves (maximum angle: 90°), is made of a material that complies with the standards (which vary from nation to nation) and iv) is smooth on the inside. [. . . ] Extend the lower pipe downward setting it against the hood. Install the carbon filter by pressing the 2 tabs on the filter down into the special housing (Fig. Depending on the model, the unit is equipped with the following commands: CONTROLS shown in Fig. 14: P1 Switches LIGHTS on and off P2 min and MAX LIGHT intensity P3 Nothing happens when pressed with motor OFF. When pressed with motor ON decreases speed until switch-off. Kept pressed for 2" with motor OPERATING, switches off motor and stores the speed. P4 When pressed with motor OFF, switches on the motor at stored speed in switch-off or first speed phase When pressed with motor ON, increases speed. L1 and shows current speed (GREEN) P5 Resets filter reset count with motor OFF. L2 Shows: 1) with motor off, the FILTER RESET IN RED, (30hours Steady LED, 120hours flashing LED) 2) In FLASHING GREEN the TIMER 5' CONTROLS shown in Fig. P3) OFF/- Motor: Speed drop until minimum speed is reached. if pressed for 2" , motor switches off. CAUTION: Do not handle glass bulb with bare hands. If, after replacing the halogen lights, these fail to work, allow the appliance to cool and then interrupt power for a few seconds. The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account. The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other than electricity (central heating systems, thermosiphons, water-heaters, etc. Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct. In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose. The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity (gas, oil, coal heaters, etc) operate at the same time. In fact the intake hood, disposing of air, could create a vacuum in the room. the vacuum should not exceed 0 , 04mbar. This prevents the gas exhausted by the heat source from being intaken again. [. . . ] In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. If your unit features a power lead and plug, position this so the plug is accessible. Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance. Avoid using materials which could cause spurts of flame (flambées) near the appliance. [. . . ]