User manual ROSIERES GS 40

[. . . ] Keep packing materials such as plastic bags, polystyrene, or nails out of the reach of children because they are dangerous for children. The company shall not be liable if the instructions provided in this document are not complied with. The parts of this appliance that may come into contact with foodstuffs comply with the provisions of EEC Directive 89/109. This appliances complies with Directives 89/336/EEC, 73/23/EEC and following changes. [. . . ] Set the empty oven to the maximum temperature and leave on for about 1 hour, this will remove any lingering smells of newness. Ensure that the room is well ventilated while this is being done. THINGS TO REMEMBER Confirmation of operation: modification must be confirmed by pressing the central button, during 1 second. Stopping the oven: this may be necessary if you have input an incorrect instruction. Child safety device: To lock the oven controls, select the child safety device. refer to the section entitled "Programming - The child safety device". The cooling fan: this protects the control panel and electronics from heat damage. It begins and then stops automatically even when the oven is switched off. Oven lighting: By turning to the light symbol, you can switch on the oven light when it is not in use. When the oven is in use, the light stays on during all of the oven functions and when the door is opened. 3- The hours will then flash, set with the central button by turning to the "-" or "+", confirm by pressing the central button. By sliding the drip tray underneath the shelf it will ensure that any juices are collected. For best results always make sure that the food is not too close to the grill element and turn the food over half way through the cooking time. ROTISSERIE + FAN The advantage of using the top oven element at the same time as the fan and rotisserie is that the food is evenly cooked, preventing it from becoming dry and tasteless. The rotisserie is programmed to continue rotating for approximately five minutes after cooking, making full use of the residual oven heat. FUNCTION MODE according to the oven model It can be modified within a pre-determined range - see the table above. The temperature display is fixed but can be modified during the cooking cycle. The indicator light flashes until the selected temperature has been reached. An audible signal sounds at the end of this operation and the indicator light becomes fixed. 3- A cooking time and an end of cooking time can be programmed by turning the programme selector knob to "cooking time" or "end of cooking time". When you have done this, do not forget to turn the programme selector knob back to to confirm the new setting. For more details about programming, refer to the chapter entitled PROGRAMMING. [. . . ] To activate : turn the function selector knob to child safety and keep the central button pressed in for 3 seconds. Turn the function selector knob to child safety and keep the central button pressed in for 3 seconds. *Nota : in all cases, for reasons of safety, even when the controls are locked, the oven can be switched off by turning the selector knob to 0. The display contrast can be adjusted at any time. [. . . ]