User manual ROSIERES HOC 90

[. . . ] Use The cooker hood is provided with an upper air exit B for discharging fumes externally for models including chimney flue C ( Suction Version A- exhaust pipe 13A not supplied). In the instance where it is not possible to discharge cooking fumes and vapours externally even if utilising the model with chimney flue C, the cooker hood may be used in the filter version F by mounting two active carbon filters E, the fumes and vapours are then recycled via the upper grill G (depending on the model the grill may be directly placed on the chimney flue or via the mounting of two small grills ­ 16F). If in possession of a model with grill placed on chimney flue then two H extensions must be placed on the deflector 13F. The models provided with small dome D may only be used in the filter version F. [. . . ] The models without suction motor operate only in the suction version and must be connected to a peripheral suction unit (not supplied). Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. Operation The cooker hood is provided with a key or pushbutton control panel situated of the frontal part of the cooker hood, depending on the basis of the cooker hood type in possession. For proper operation consult the text below and the relative illustration: a. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Initially, only LED 4 will flash, then after the 3 seconds have passed, LED 5 will also start flashing, indicating that the active carbon filter saturation control system is active. When washed in a dish-washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. Only for model with electronic control panel: Once the grease filters have been cleaned, press button 1 (see preceding page) for about 3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. Carbon Filter (2 pieces ­ only for filter version) The active carbon filters E are not washable nor regenerative. It should be changed every 6 months in normal use. the active carbon filters capture unpleasant cooking odours. Apply one on each side covering both grills protecting the motor propeller, then turn the filter central handles P clockwise. In order to dismantle turn the central handle P anti-clockwise for each filter. Only for model with electronic control panel: Once you have replaced the charcoal filter, press button 1 (see preceding page) for about 3 seconds until you hear the acoustic signal (beep). If the cooker-hood comes with a halogen light, take off its protection by unscrewing (Z1) or by removing it (Z2 lifting with a small flat edged screwdriver). [. . . ] If the cooker-hood comes with a halogen light, take off its protection by unscrewing (Z1) or by removing it (Z2 lifting with a small flat edged screwdriver). Children should not be allowed to tamper with the controls or play with the appliance. Do not use the cooker hood where the grill is not correctly fixed!The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. [. . . ]