User manual ROSIERES HSM 790 IN

[. . . ] 6) of the telescopic flue to the wall behind and to the ceiling on the hood perpendicular; for this operation make four Ø8 mm. The centre axis of the support must coincide with the line drawn on the wall. [. . . ] The duct must be slightly slanted upwards (about 10%) in horizontal sections to expel air easily to the outside. Electrical connection: The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. A) With a pencil trace a line on the wall corresponding with the centre line of the hood to facilitate positioning and installing of the hood (Fig. 3 - the lower edge of the template corresponds with the lower edge of the hood and the hatched line must correspond with the line traced on the wall behind). E) Hook the hood to the bracket and level it by turning the screws on the side behind the hood outlet as necessary (Fig. F) Make sure the line traced on the wall is perfectly central compared to the hood (Fig. G) Once the right position is established, mark with a pencil the positions of the fastening bottom and upper holes (Fig. 5) and measure the distance between the connecting ring and the point where the exhaust duct is to pass in order to establish the length of the duct. [. . . ] When cleaning glazed stainless steel parts, pass the cloth in the same direction as the glazing. To avoid risk of fire, observe these rules for cleaning the appliance and replacing and cleaning the filters. [. . . ]