User manual ROSIERES LV 522

[. . . ] THE SEMI-RAPID BURNER 1, 45 kW Use the small burner for small pans. Do not use pans with a diameter of less than 12 cm. To make the most efficient use of the burners, it is recommended not to use pans with smaller diameters than shown below : * Ultra-rapid Ø 20 cm and more * Rapid Ø from 16 to 18 cm * Semi-rapid Ø 12 cm Pans with curved, ridged or warped bottoms are not recommended. Food is not cooked any more quickly this way. [. . . ] To remove stubborn stains use a spot of non-abrasive cream and a sponge and then rinse with clean water. regular cleaning is essential to maintain the original appearance of the appliance. Be careful not to let any water get into the burners. the burner caps : The burner caps are simply placed on the burners. Just lift them off and clean with a damp, slightly soapy sponge. Do not immerse the burner caps or burner support in cold water immediately after use to avoid cracking the enamel from the thermal shock. The use of abrasive cleansers is not recommended as they scratch and dull the enamel. If the holes are clogged, brush the caps using soapy water and dry with a clean cloth. The burner support : regular cleaning enables you to keep the original appearance. When re-assembling the burners, make sure that the burner caps and the burners themselves are correctly seated. When re-fitting the caps, make sure that the recess is fitted correctly into the projection. It must be installed in accordance with the regulations in force in the country of use. Care must be specially taken to follow the regulations regarding ventilation. The airflow necessary to the combustion must be 2 m3/h by kW of power. GAS CONNECTION - It must be carried out in accordance with the regulations in force in the country of use. However, in all circumstances the gas supply pipe should be fitted with a stop tap, a pressure regulator or a pressure reducer release valve for LPG. The stop tap, pressure regulator or pressure reducer release valve should only be used in accordance with the regulations in force in the country of use. BUILD-IN HOB : Butane gas Rigid hose - Flexible hose with mechanical nozzles (1) Propane gas Rigid hose - Flexible hose with mechanical nozzles (1) Natural gas Rigid hose - Flexible hose with mechanical nozzles (1) (1) The connection must be made in such a way that the flexible hose must never be in contact with hot parts of the appliance and must be placed in such a way to be examinable on all its length. If the hob is to work with another type of gas, the appliance must be adapted accordingly ; to do this, proceed as follows : - put the proper injector in (which will insure a normal flow), - regulate the air flow, and, - regulate the minimum flow. HOB INJECTORS : - Remove the pan supports and the burners, - Unscrew the injectors, using the special key (supplied with the appliance), - and replace the injector with ones specially designed to operate with the new type of gas (see page 10). REGULATION OF THE AIR FLOW : When necessary (see the table) this regulation is very important because it obtains proper combustion and the best efficiency of the burners. The chart mentionned the theorical size "X", it can be necessary to improve the setting in a more or less 1 mm in order to get a perfect flame. [. . . ] The installation must be in conformity with standard directives. Rosières declines all responsability for any damage that may be caused by unsuitable or unreasonable use. Connection to the mains electricity supply should be through a plug with an earth terminal, or through an omnipolar switch, contact or cut-out, with a gap between the contacts of at least 3 mm. the electrical installation should be protected by a fuse , properly earthed , and including wires of a sufficient section to supply the product correctly. [. . . ]