User manual ROSIERES RBE 95

[. . . ] Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion. The negative pressure in the environment must not exceed 4Pa (4x10-5 bar). Before connecting the model to the electricity network: - control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. if in doubt ask a qualified electrician. [. . . ] 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Insert the upper flue into the lower flue. Fix the lower flue to the hood using the screws B provided (Fig. 4), extract the upper flue up to the bracket and fix it with the screws B (Fig. If your appliance has the lower connections indicated as in Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. The filters are not washable or re-usable and must be replaced at least once ever y four months. The active carbon filter saturation level depends on the frequency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended use of the light reduces the average duration of the bulb. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Touching the key at 3rd speed, the intensive function runs for 10', then the appliance go back to work at the original speed. during this function the display blinks. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. the Timer is deactivated by re-pressing Key E. When the Timer is activated the decimal point must flash on the display. The "clean air" function is activated by pressing key E for 2 seconds when the appliance is switched off. [. . . ] 5 seconds, the carbon filters must be replaced. After the clean filter has been replaced, the electronic memory must be reset by pressing button A for approximately 5 seconds, until the light on the button stops flashing. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. replace the bulbs with new ones of the same type. [. . . ]