User manual ROSIERES RBS9485IN

[. . . ] Before connecting the model to the electricity network: - Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. if in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. [. . . ] The charcoal filters are already fitted to the appliance (Fig. The appliance switches on at speed level 1, If the cooker hood is on depress the push-button for 2 sec. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Display C = indicates the motor speed level selected and activates the timer. Touching the key at 3rd speed, the intensive function runs for 10’, then the appliance go back to work at the original speed. During this function the display blinks. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. the Timer is deactivated by re-pressing Key E. When the Timer is activated the decimal point must flash on the display. The “clean air” function is activated by pressing key E for 2 seconds when the appliance is switched off. This switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary movement of the peripheral segments must be visualised on the display. When this time has passed the motor switches off and the fixed letter “C” must be visualised on the display until the motor re-starts after 50 minutes for another 10 minutes and so on. Press any key apart from the light keys to return to normal functioning. € Active carbon/grease filter saturation: - When display item C flashes, at a speed where it alternates with the letter F (e. 1 and F), the grease filters must be washed. - When display item C flashes, at a speed where it alternates with the letter A (e. 1 and A), the carbon filters must be replaced. After the clean filter has been positioned correctly, the electronic memory must be reset by pressing button A for approximately 5 seconds, until the indication F or A shown on the display C stops flashing. 9 A) luminous the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III F = AUTOMATIC STOP TIMER - 15 minutes • By pressing key F for two seconds (with the hood switched off ) the “clean air” function is activated. This function switches the appliance on for ten minutes every hour at the first speed. As soon as this function is activated the motor starts up at the first speed for ten minutes, During this time key F and key C must flash at the same time. [. . . ] This will help to avoid wasted journeys being made by technicians, thereby (and most significantly) saving the corresponding callout charges. For størst mulig sikkerhed, sørg for en passende ventilation af rummet. Denne funktion tænder motoren i 10 minutter for hver time på første hastighedstrin. € Antifettfilteret brukes til å samle opp alle fettpartikler som finnes i lufta, og dermed er det utsatt for metning (tiden det tar for at filteret blir fullt avhenger av måten apparatet brukes på). [. . . ]