User manual ROSIERES RBVS685TIN

[. . . ] € • Children should be supervised to ensure that they do not play with the appliance. € Do not flambé under the range hood. € The range hood is not intended to be installed over a hob having more than four hob elements Electrical Shock Hazard Only plug this unit into a properly earthed outlet. If in doubt seek advice from a suitably qualified engineer. [. . . ] Then, attached the exhaust pipe onto the one-way-valve as shown below. Place the glass in appropriate position on the top the cooker hood. In order to avoid the glass cracking, please do not tighten the screws too strongly. By Put the inner chimney into outer chimney . Then pulling out the inner chimney upwards. Sliding the chimney to adjust the chimney height. When the height you required is reached, then hang the fixing hole to the fixing screws as showed in below pictures. Screw and tighten the plate II onto the wall with 2 screws provided. Assembly the chimney onto the unit and fix it with 2 screws. Plate II Wall plug Screw 4mm x 8mm Screw (4mm x 30mm)
 10 INSTALLATION (VENT INSIDE) If you do not have an outlet to the outside, exhaust pipe is not required and the installation is similar to the one show in section “INSTALLATION (VENT OUTSIDE)”. Activated carbon filter can be used to trap odors. Never use metal pads, chemical, abrasive material or stiff brush to clean the unit. Monthly Cleaning for Grease Filter ESSENTIAL: Clean the filter every month can prevent any risk of fire. The filter collects grease, smoke and dust…. So the filter is directly affecting the efficiency of the cooker hood. If not cleaned, the grease residue (potential flammable) will saturate on the filter. Clean it with household cleaning detergent. Annual Cleaning for Activated Carbon Filter Apply SOLELY to unit that installed as a recirculation unit (not vented to the outside). This filter traps odors and must be replaced at least once a year depending on how frequent the cooker hood used. Changing a light bulb Remove the screws on the glass, take off the hood glass. Find the bulb that requires replacement, you will find it located in the light fixture which is inside the exposed section of the canopy. # Disconnect the light wiring point and remove the bulb holders and wiring from the hood. [. . . ] Too long distance between the unit and the cooking plane Solution Switch off the unit and repair by qualified service personnel only. Plug in to the power supply Switch of the unit and repair by qualified service personnel the unit and repair Switch off only. Unit and Take down the check whether the bracket is in proper location. Readjust the distance to 65-75cm Serious Vibration of the unit Suction performan ce not good CUSTOMER ASSISTANCE SERVICE If you cannot identify the cause of the operating anomaly, switch off the appliance and contact the Assistance Service. [. . . ]