User manual ROSIERES RDM 90 SIN

[. . . ] Securing the telescopic flue: Basic installation requirements: ­ Set the electrical power supply within the space covered by the decorative flue. ­ If your unit is installed in an Exhaust hood, prepare the air exhaust hole. Place bracket (W) 50 mm from the ceiling and position this on the vertical of your hood, with the aid of the notches on the centre of the bracket (Fig. 5); using a pen, mark the 2 holes on the wall and then make the holes and fit the screw anchors provided and proceed to secure the bracket using the 2 screws (provided). [. . . ] Manual function: When the LED P2 is off, you are in manual mode. Press P3 when in manual mode to turn on the motor in 1st speed with the relevant LED on. Holding it down for 2 seconds, the motor is turned off. Press P4 to go to 2nd speed with the relevant LED on and P5 to go to 3rd speed with the relevant LED on. P3) OFF/- Motor: Speed drop until minimum speed is reached. if pressed for 2" , motor switches off. If pressed for 2" with FILTER RESET on HOUR count reset. P4) ON/+ Motor: Starts motor and increases motor speed until top speed is reached P5) ON/OFF: Switches Sensor off and on( AUTOMATIC or MANUAL mode). In Automatic mode, LED L2 is on and L1 shows operating speed In Manual mode, LED L2 is off. Indicate set speed L2) 4 LEDs GREEN indicates AUTOMATIC mode OFF indicates MANUAL mode RED indicates Filter Reset FILTER RESET: shown with Motor Off for 30": After 30h the LED L2 becomes steady RED. After 120h LED L2 becomes flashing RED Reset by means of P3 SENSITIVITY: In manual mode, by pressing P5 and P4 together, sensitivity mode is entered. 10/A) By pressing P5 the sensitivity can be stored, with return to manual mode Grease filters: special attention must be given to the grease filters which must be periodically cleaned, whenever the grease filter alarm trips. Charcoal filters: if the filtering version appliance is used, the charcoal filters will have to be periodically replaced when the charcoal filter alarm trips. for instructions on the filter Alarm , refer to the Controls paragraph. Lighting: to change the halogen bulbs open the cover levering from the proper slots (Fig. CAUTION: Do not handle glass bulb with bare hands. If, after replacing the halogen lights, these fail to work, allow the appliance to cool and then interrupt power for a few seconds. Posez le support (W) à 50 mm du plafond et placez-le à la verticale de votre hotte en vous aidant des encoches se trouvant au centre du support (Fig. The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account. The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other than electricity (central heating systems, thermosiphons, water-heaters, etc. Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct. [. . . ] When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). [. . . ]