User manual ROSIERES RDM 917 IN

[. . . ] € La distance minimum entre la surface de support des récipients de cuisson sur le dispositif de cuisson et la partie la plus basse de la hotte pour cuisine doit être de 45 cm au moins. € Fixation au mur: Tracer le bord inférieur de la hotte sur le mur en tenant compte des mesures indiquées dans la figure 4A et de la distance minimale du plan de cuisson (Fig. - 16 - ENGLISH GENERAL Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations. [. . . ] 4) and then remove them from safety pins N (Fig. To put them back perform the operation in reverse order. During this disassembly and assembly operation ensure to hold the panel securely to prevent accidental falls. € Wall mounting: Trace the bottom side of the hood on the wall. consider the measurements shown in Fig. 4A and minimum distance from the cooking surface (Fig. - Position the fixing template on the wall, making sure that the line coincides with the line previously made on the wall. - Mark the fixing holes and cut them into the material (Fig. - Fix the 2 top screws K and screw anchors (Fig. - Position the appliance at the wall (Fig. - Make sure the 2 levelling screws J are tightened (Fig. - Align the appliance horizontally using the two levelling screws J (Fig. - Once the adjustment has been made, fasten the hood permanently using the screws K (Fig. - For easy accessibility to the motor unit in the case of assistance, after having levelled and fixed the appliance definitively, we recommend that the brackets are removed (Fig. - When carrying out the fixing operations, use only screws and screw anchors suited to the type of wall (e. - I f the screws and screw anchors are supplied with the appliance, make sure that they are suited to the type of wall to which the hood must be fixed. € Installation of models without decorative ducts: Extractor hood - Unclip the canopy M and remove the grille E (Fig. - Pass the power supply cable through the slot in the canopy M, as indicated in Fig. - Taking the grommet H, position it between the power cable and the slot (Fig. - Connect the flexible hose L (not supplied) to the hood (Fig. - Re-position the small cupola M paying attention that it is hitched perfectly to the fixing pins G (Fig. € Filtering version: - Unclip the canopy M and remove the grille E (Fig. [. . . ] The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. € The anti-grease filter is responsible retaining the grease particles suspended in the air, therefore it is subject to clogging with variable frequency according to the use of the appliance. - To prevent the danger of possible fires, at least every 2 months one must wash the anti-grease filters by hand using non-abrasive neutral liquid detergents or in the dishwasher at low temperatures and on short cycles. - After a few washes, colour alterations may occur. [. . . ]