User manual ROSIERES RFV460EIX

[. . . ] 32 kg 25 EN We ask you to read the instructions in this booklet very carefully as this will allow you to get the best results from using your microwave oven. kEEP THE DOCUMENTATION OF PRODUCT FOR FUTURE REFERENCE. THIS Environmental protection Disposal of the packaging The packaging bears the Green Dot mark. Dispose of all the packaging materials such as cardboard, expanded polystyrene and plastic wrapping in the appropriate bins. [. . . ] After the water is pumped back to the water tank, the display will show the message “DEP” requiring the following actions: 1. Dry the water tank and introduce it back into the slot located above the cavity. Leave the appliance door open so that the cooking space can cool down and dry completely. IMPORTANT NOTE: It is advisable to remove the water tank and empty it after a cooking cycle. This prevents the formation of bacteria and limestone inside the appliance. If the water tank has not been removed from the oven and a new cooking cycle is started, the oven displays the warning “DEP”. This function gradually releases the steam from the cavity, so that there is no sudden rush of steam when the appliance door is opened. This function takes around 3 minutes and during it the display shows the word “VAP”. When opening the door during or upon completion of the cooking cycle, be careful of the flow of hot air and/or steam coming out of the cooking chamber. Step back or to the side to avoid burns. The cooling fan can continue to run for a certain length of time after the appliance has been switched off. This is a normal function that is meant to reduce the temperature inside the oven. When the display shows the word “DEP”, this means that the water was pumped and that the water tank can be removed. Remove the water tank and dry it thoroughly. Let the cooking space cool down for a moment and then clean and dry it with a cloth. The door should be left open for some time so that the appliance can dry completely. Altering parameters The duration can be altered when the oven is operating or when the cooking process has been interrupted by turning the rotating knob. The new duration defined is valid when the display stops blinking. The temperature can only be altered when the oven is interrupted. Alter the temperature by pressing the Function Selector key and turning the Rotating Knob until the new temperature is blinking. Validate the selection by pressing again the Function Selector key. Residual water in the oven To reduce the residual water in the oven, it is recommended to insert a tray in the bottom rack level. [. . . ] Check if: - You have selected the correct operating times and temperature setting. - The food you have put inside the oven is a larger amount or colder than you usually put in. If the message “Err_” appears in the display, please contact the Customer Care. EN The appliance still makes a noise after the cooking process is finished! [. . . ]