User manual ROSIERES RGM 91 IN

[. . . ] Before connecting the model to the electricity network: - Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. if in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. [. . . ] Before fixing the appliance in place, take the lower connector and use a pair of pliers to bend the tab inwards, as shown in figure 5, stage 1. Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance must be installed as an extractor version, make sure an air exhaust hole has been prepared. Then fix it to the ceiling using the screws A (Fig. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Insert the upper flue into the lower flue. Fix the lower flue to the hood using the screws B provided (Fig. 5 - Stage 2), extract the upper flue up to the bracket and fix it with the screws B (Fig. Remove the charcoal filters already fitted to the appliance by turning them 90° anticlockwise (Fig. Quency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended use of the light reduces the average duration of the bulb. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. [. . . ] The active carbon filters are used to purify the air which is released back into the room. The filters are not washable or re-usable and must be replaced at least once every four months. - check that the plug has been inserted into the power socket correctly. [. . . ]