User manual ROSIERES RHC 927

[. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ] check that the suction/filter selector is in the filter (F) position. The models provided without suction motor may function only in the suction version and must be connected to a peripheral suction unit (not supplied). Installation - Do not tile, grout or silicone this appliance to the wall. Do not fix chimney flue to furniture or fly over shelves unless the chimney flue can be easily removed, in case maintenance is ever required. The cooker hood must be placed at a minimum distance of 60 cm from the cooking plane for electric cookers and 75cm for gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this has to be taken into account. The cooker hood may be installed on the wall or on the base of a cabinet; if supplied, use the hole gauge H to drill the correct distance, otherwise lean the cooker hood on the wall or on the base of the cabinet and mark the holes with a pencil. Wall mounting - Insert the wall screw anchors J in the drilled holes And the two K screws in the upper drill holes, remove the grill and hook the cooker hood to the 2 screws, finally from the inside, insert the third screw L and lock them all in. Carbon Filter - it may be one of the following types: Rectangular S1 or S2 or S3: to be replaced every 6 months Mounting (S1 or S2) : insert the rear side T and hook further to the front (U). Mounting (S3): Remove the cover W by rotating the O knobs to 90° , then close the cover. Bayonet mount position the filter in the middle of the motor protection grill covering ensuring that the reference to X1 or X2 or X3 on the carbon filter match the Y1 or Y2 references on the conveyor, then turn clockwise; in case of dismounting turn anticlockwise, if provided with a Z tape remember to gently lift first. Replacing lightbulbs 40W - Unscrew the damaged light bulb and Replacing the halogen bulbs - Access the light compartment ­ Replace with an incandescent oval light bulb with a maximum of 40W E14. Remove the grill in order to reach the light bulb area. Cabinet fixing - Affix the cooker hood with the 4 M screws from Electrical connection - The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. [. . . ] Frying of foods must be kept under close control in order to avoid overheated oil catching fire. Carry out fumes discharging in accordance with the regulations in force by local laws for safety and technical restrictions. [. . . ]