User manual ROSIERES RHD 1 IN

[. . . ] Drill two holes (Ø 8 mm) in the wall at the points indicated, insert the stops (Ø 8 mm) and screw in the hooks provided. Hang the hood and adjust its position using the screws on the hooks. The reference point "a" marked on the body of the extractor hood must coincide with the line you have drawn on the wall. [. . . ] Fix the top part the telescopic outlet pipe to the relative support, using the two 3 mm dia x 9 mm screws R. Slide the bottom part of the telescopic outlet pipe downward until it rests in its housing on the top of the hood. -- The hood is provided with a motor with several speeds. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. -- We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. = Fan off = Fast speed switch (P+ the led on the bottom right side of the display flashes), This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button and . Initially, only letter F will fbe displayed, then after the 3 seconds have passed, letter C will be displayed as well, indicating that the carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: letter C appear on display and after 3 seconds letter it disappear and the device will be switched off. = Decrease fan speed button for reducing speed of motor from 3 down to speed 1. = Increase fan speed button for increasing speed of motor from 1 to 3. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Before Always press the fan off button disconnecting the hood from the mains supply. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. [. . . ] If this is the first time a new carbon filter is being inserted, once the grease filters have been inserted check that the saturation indicator for the carbon filter is active. Remove the screws that protect the light bulbs. Remove the damaged light bulb and replace with the same type max. [. . . ]