User manual ROSIERES RHD 4 IN

[. . . ] The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: ­ the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol [ ], or coloured green or green and yellow; ­ the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; ­ the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When making the electrical connections, check that the current socket has a ground connection and that the voltage values correspond to those indicated on the data plate inside the appliance itself. In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. [. . . ] Use of charcoal filters is therefore unnecessary. Wall fixing with brackets Make all the necessary holes on the wall using the relative boring template. Apply the supplied brackets to the wall using the relative screws and screw anchors (Fig. 5A) have been sufficiently slackened to allow the hood itself to be fitted in place. Now fit on the hood using the relative rectangular slots situated at the rear of the appliance (Fig. Since these coupling slots are dimensionally larger than the brackets, the horizontal position of the appliance can be adjusted by sliding to the right or left in order to align the equipment. The appliance can be regulated in height by means of the relative bracket adjuster screws (Fig. Once having regulated the equipment, fix everything in place by tightening screws A (Fig. Particular care must be paid to the antigrease filters which must be periodically cleaned in relation to use (at least once every two months). Remove the anti-grease filters and wash them either by hand or in the dishwasher using neutral detergent. Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). avoid using abrasive or corrosive products. To clean painted appliances on the outside, use a cloth dipped in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best to use specific products, following the instructions on the products 3), the appliance must be connected to an ducting apparatus/motor which works on its own using the appliance as a union for the air to be scavenged. [. . . ] When using the filtering version of the appliance, the charcoal filters must be changed according to use (Fig. Remove the filters rotating them and replace them rotating into the opposite direction. If the halogene bulbs need changing, slacken the ring nut in an anticlockwise direction and remove the bulb itself (Fig. [. . . ]