User manual ROSIERES RHD 6 IN

[. . . ] Located in the upper part of the flue, this baffle recycles the air to the environment (Fig. 2) an exhaust duct conveys the steam and cooking odors directly outside through the wall/ceiling. Therefore they do not require charcoal filters. INSTALLATION Remove the grease filters before proceeding with the assembly instructions. [. . . ] Securing the decorative flues: basic installation requirements: ?Set the electrical power supply within the space covered by the decorative flues. If your unit is installed in Ducting version, prepare the air exhaust hole. In the Ducting version, to get optimal conditions the air venting pipe should: ?have the lowest number of bends (max bende angle: 90). be made of material approved by local authorities (according to the State). have its inner side as regular and smooth as possible. It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 150 mm). Using the supplied screws and screw anchors, fix the upper flue bearing bracket to the ceiling and/or wall, checking that it is aligned with the hood (Fig. Prepare the decorative flues, remembering that their final position must be that illustrated in Fig. The air disposal gratings in the filtering version must be positioned in the upper part. For the ducting version turn upside down the upper flue so that the air disposal gratings are downwards. Ducting version : Connect the air outlet pipe to the air vent of the hood. Use a flexible pipe and lock it to the air vent of the hood with a metal hose clamp (pipe and clamp are not provided). Make the electrical connection of the hood. Take the telescopic flues and check that they are coupled properly: the openings in the upper flue must be positioned at the bottom so that they are hidden; if necessary, turn around the upper flue. Insert the telescopic flues resting them on the hood. Lift the upper flue up to the ceiling and fix it to the bracket with the 2 screws (A) ?Filtering version : Separate the telescopic flues and take the upper flue (the one with the air openings) and fix the baffle to it with the 4 screws provided (Fig. 9B) to the baffle, locking it with a metal hose clamp (pipe and clamp are not provided). [. . . ] When using the filtering version of the appliance, the charcoal filters must be changed according to use, usually every six months. Remove the filters rotating them and replace them rotating into the opposite direction (Fig. Lighting: Depending on the model purchased, see Fig. 12: to change the light bulb, remove the cover after having desinserted the locking screw. [. . . ]