User manual ROSIERES RHD 7 S

[. . . ] If the height of the hood also requires adjustment, use the special regulation screws (V) (supplied). Once regulation has been completed, finish securing the hood with 4 more screws (M): mark the points for the 4 holes on the wall, remove the hood and drill (8mm diameter holes); then use the plugs and screws to complete installation. Rest the lower edge of the panel behind the stove and anchor the upper edge to the wall using the two holes found on the panel. insert the screws and plugs provided (A). [. . . ] P4) ON/+ Motor: Starts motor and increases motor speed until top speed is reached P5) ON/OFF: Switches Sensor off and on( AUTOMATIC or MANUAL mode). In Automatic mode, LED L2 is on and L1 shows operating speed In Manual mode, LED L2 is off. Indicate set speed L2) 4 LEDs GREEN indicates AUTOMATIC mode OFF indicates MANUAL mode RED indicates Filter Reset FILTER RESET: shown with Motor Off for 30": After 30h the LED L2 becomes steady RED. After 120h LED L2 becomes flashing RED Reset by means of P3 SENSITIVITY: In manual mode, by pressing P5 and P4 together, sensitivity mode is entered. By pressing P5 the sensitivity can be stored, with return to manual mode CONTROLS shown in Fig. 16: P1- Lights ON/OFF; filter alarm RESET: if held pressed down for about 2 seconds when the filter alarm is active, the hour counter is reset. Filter alarm: after 30 hours the light button LED comes on and stays on for 30 seconds; after 120 hours it is activated for 30 seconds but with the LED flashing. The RESET is highlighted ONLY when the motor is OFF, both in automatic and manual mode. Automatic function: To activate the automatic function press P2, highlighted by the corresponding LED coming on; the flashing LED indicates that the sensor is waiting for data. To set the sensitivity: in manual mode and with the motor off press P2 and P3 simultaneously; the sensitivity already set with the P3 or P4 or P5 LEDs is highlighted. to modify it , press P3 or P4 or P5 (MIN , MED , MAX) , and again press P2 to store it. At this point, the desired sensitivity has been stored; press P2 again to deactivate the automatic mode. Manual function: When the LED P2 is off, you are in manual mode. Press P3 when in manual mode to turn on the motor in 1st speed with the relevant LED on. Holding it down for 2 seconds, the motor is turned off. Press P4 to go to 2nd speed with the relevant LED on and P5 to go to 3rd speed with the relevant LED on. Grease filters: special attention must be given to the grease filters which must be periodically cleaned, whenever the grease filter alarm trips. Charcoal filters: if the filtering version appliance is used, the charcoal filters will have to be periodically replaced when the charcoal filter alarm trips. for instructions on the filter Alarm , refer to the Controls paragraph. Removing the charcoal filter/s: first of all, remove the grease filters; push the catch inwards (Fig. [. . . ] When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). [. . . ]