User manual ROSIERES RHE 61

[. . . ] Vapour collector remain visible on the letter C of the drill holes diagram) drill B. Outlet E with connection ring F; a discharge pipe G1 of the Fasten the cooker hood with 4 screws (Fig. 5, Q) to the cooker hood with two In cases where external fumes and vapour discharge is not screws and plastic washers (Fig. [. . . ] 2), remove the vapour collector Do not use the cooker hood where the grill is not correctly (freeing the locking releases I-Fig. 4, J-the channel used for fumes discharged by appliances powered arrow on the diagram should face the upper border of the by other than electricity. The environment must always be aesthetic panel), perform blind holes as indicated (Kadequately aerated when the cooker hood and other Fig. 4), place the vapour collector over the aesthetic panel appliances powered by other than electricity are used at and affix with 8 screws (Fig. 4 , L) , remount the cover on the the same time. Flambé cooking with a cooker hood is cooker hood firstly in the upper track (Fig. The use of a free flame is damaging to the filters lower track (Fig. 4-M2), where the cooker hood is provided and may cause fire accidents, therefore free flame cooking must be avoided. Frying of foods must be kept under close with revolving locking releases (Fig. 3) these should be control in order to avoid overheated oil catching fire. Carry turned in the opposite direction of the release to avoid that out fumes discharging in accordance with the regulations the vapour collector may be unintentionally released during in force by local laws for safety and technical restrictions. Affixing the cooker hood to side cabinets use the drill Operation holes diagram N2, position the diagram on the anterior All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Closely follow the instructions set out in this manual filter carry out the instructions in reverse. The control panel is provided with a suction power selection The procedure for mounting and dismounting the carbon switch and cook top light switch. [. . . ] 8, Y1) then secure in the lower section with the two hooks provided on the filter (Fig. Circular (it should be replaced every 4 months)-Bayonet insert position the filter in the centre (if necessary use the hooks (Fig. 8, A2) on the conveyor, turn clockwise; for dismounting the carbon All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. [. . . ]