User manual ROSIERES RHI 694 IN

[. . . ] D= distance between the lower park of the hood and the support surfaces of the cooking device containers. Fix the lattice girder with the 8 D screws (Fig. 1) onto the ceiling and make the holes indicated and also prepare the area for electrical connection. The side with the arrow on the template corresponds to the front part of the hood (commands side). [. . . ] Insert the flue carefully so as not to avoid damaging the electric cables and the commands box. Remove the carbon filter holding frame and tighten internal screw R (Fig. 3) that adjusts the position of the commands box so that the keys extrude from the flue. Block the position tightening the lock nut on the screw. 5), placed between the bulbs, temporarily and fix filter holder mask U (Fig. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Speed 2 LED and metal grease filter saturation LED (in this latter case, the LED will flash - See instructions on grease filter cleaning). Once the grease filters have been cleaned, press button 1 for about 3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. Speed 3 LED and active carbon filter saturation LED (in this latter case, the LED will flash - See instructions on active carbon filter replacement). Once you have replaced the charcoal filter, press button 1 for about 3 seconds until you hear the acoustic signal (beep). Initially, only LED 4 will flash, then after the 3 seconds have passed, LED 5 will also start flashing, indicating that the active carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: after 3 seconds LED 5 will stop flashing and the device will be switched off. Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. The eventual frame supplied with the hood is not, therefore, to be used. Insert it into its housing and fix it turning the 2 plastic knobs. [. . . ] remove the filter holder frame by turning the knobs (g) 90° that affix the chimney to the cooker hood. Insert the pad (i) of activated carbon into the frame (h) and fit the whole back into its housing (j). It is possible to use a traditional carbon filter, neither washable nor regenerable, to be replaced every 3 - 4 months. On the product, or on the documents The symbol accompanying the product, indicates that this appliance may not be treated as household waste. [. . . ]