User manual ROSIERES RHI 9101 SP

[. . . ] It is also advisable to avoid any drastic changes in pipe section (diameter: 150 mm). ASSEMBLING - Using the special drilling template, drill the holes for fixing to the ceiling on the vertical side of your hob. carefully observe all the indications for final positioning of the apparatus. [. . . ] 14L) and assemble it onto the air venting opening of the hood, pressing slightly. Fit the hood to the telescopic structure by means of 4 screws (provided) ­ Fig. Fix the air evacuation pipe onto the reduction (L). Make the electrical connection by means of the power cable. Remove the adhesive tape and pull the lower flue downwards, placing it gently onto the apparatus. Remove the grease filter by pushing the catch towards the rear of the hood and turning the filter outwards. 17) by inserting the two filter clips in the slots and turning the filter towards the inside of the hood. Push button P2: MOTOR: Switch on and off the motor. Switch on the motor to the latest used speed and if pressed different times changes the speed in a cyclic way (1, 2, 3, 4, 1, 2. ) The speed set is visualized by the icon D5 and simultaneously the icon D8 switches on ( the speed of the rotational movement is proportional to the speed ). To the maximum speed the icon D8 switches off and the icon D3 switches on. To switch off the motor, press the push button P2 for about 2 seconds (the set speed is memorized). It switches on when the grease filter must be cleaned (after about 30 hours of working). One time the grease filter is cleaned, to make the hours calculation start again, press the push button P4. [. . . ] Remove the grease filter by pushing the catch towards the rear of the hood and turning the filter outwards. Wash the grease filter/s with neutral detergent. 18) appears on the control display every 120 hours of hood operation to indicate that the charcoal filter needs to be replaced. [. . . ]