User manual ROSIERES RHI 9101 SP IN

[. . . ] Prepare the connection to the mains within the telescopic flue. If your unit is installed in a ducting hood, prepare the air exhaust hole. When installing ducting hoods, to achieve the best possible conditions use an air exhaust pipe that : is as short as possible, has a minimum of curves (maximum angle: 90), is made of a material that complies with the standards (which vary from nation to nation) and is smooth on the inside. It is also advisable to avoid any drastic changes in pipe section (diameter: 150 mm). [. . . ] Take the upper flue (with the round slots) and fit it on the telescopic structure with the slots facing upwards; fit the flue to the bracket with 2 screws (Fig. Take the lower flue and fit it in the same manner as before; slide it to the top and stop it in that position using a adhesive tape (Fig. 14L) and assemble it onto the air venting opening of the hood, pressing slightly. Fit the hood to the telescopic structure by means of 4 screws (provided) ?Fix the air evacuation pipe onto the reduction (L). Make the electrical connection by means of the power cable. Remove the adhesive tape and pull the lower flue downwards, placing it gently onto the apparatus. Fitting the charcoal filter: Turn the glass panel gripping it from the font part of the hood (Fig. Remove the grease filter by pushing the catch towards the rear of the hood and turning the filter outwards. 17) by inserting the two filter clips in the slots and turning the filter towards the inside of the hood. Push button P2: MOTOR: Switch on and off the motor. Switch on the motor to the latest used speed and if pressed different times changes the speed in a cyclic way (1, 2, 3, 4, 1, 2?. ) The speed set is visualized by the icon D5 and simultaneously the icon D8 switches on ( the speed of the rotational movement is proportional to the speed ). To the maximum speed the icon D8 switches off and the icon D3 switches on. To switch off the motor, press the push button P2 for about 2 seconds (the set speed is memorized). Push button P3: Select the functions D4 (Sensor) and/or D7 (Air Refresh). It switches on when the grease filter must be cleaned (after about 30 hours of working). One time the grease filter is cleaned, to make the hours calculation start again, press the push button P4. Is activated only when the maximum speed is set. Icon D4: SENSOR: To activate the sensor function, press the push button P3. To disconnect the sensor, repeat the same operation. When the sensor activated, the hood switches on automatically in the presence of any kinds of odours or vapours, smokes or heat, caused by the cooking process and also in the presence of possible and anomalous gas emissions in environment. [. . . ] Charcoal filters: If using the hood in the filtering version, the charcoal filter will periodically have to be replaced in relation to use. 18) appears on the control display every 120 hours of hood operation to indicate that the charcoal filter needs to be replaced. Press the button P4 to restart the hour counter. 16): Turn the glass panel gripping it from the front part of the hood. [. . . ]