User manual ROSIERES RHT 619 IN

[. . . ] The following warning is valid in the United Kingdom only: As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: ­ the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol [ ], or coloured green or green and yellow; ­ the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; ­ the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When making the electrical connections, check that the current socket has a ground Connection and that the voltage values correspond to those indicated on the data plate inside the appliance itself. In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. [. . . ] To compensate possible depth voids between the appliance and the wall, a plastic SPACING BAR to be fixed at the back of the appliance by means of the three screws A is included (Fig. Cut the spacing bar according to the distance to be adjusted. Assembly under a pensile cupboard The following operations are essential for assembly: 6: Using the relative template make the 4 necessary fixing holes in the bottom of the cupboard and cut the air venting hole. Move the hood close to the bottom of the wall unit and then connect the two units by means of the 4 self-tapping screws supplied together with the appliance. When using the filtering version of the appliance, the actived carbon filters must be changed according to use (Fig. Remove the filters rotating them and replace them rotating into the opposite direction. Light bulb If the fluorescent light need changing, slacken the light cover by disconnecting the screw and remove the bulb itself (Fig. To change the rectangular halogen bulbs open the cover and remove the bulb without touching it with bare hands (Fig. 7: Take the two brackets (S) out of the accessory bag together with the 12 screws provided. Fit the brackets to the wall unit being careful to position these correctly; for this operation use the 8 shorter screws. At this point, secure the appliance to the brackets using the 4 longer screws. Ducting version: connect the flange of the hood with the air venting hole made previously in the wall/ceiling by means of an adequate tube. Filtering version: connect a proper pipe to the flange of the hood so that the air is sent outside the pensile and sent back into the room. Opening slightly the truck, the motor works at the I speed; opening a bit more, the motor works at the II speed; opening totally the truck, the motor works at the III speed. Position L: the lights switch ON and the motor switch OFF either if the truck is open or closed; the motor is always OFF. switch B: it select the speed of the motor. When the switch is in M or T position, opening the truck, the motor starts working automatically at the selected speed. 6: Met behulp van de boormal de 4 bevestigingsgaten voorzien volgens uw model in de bodem van de kast en de nodige opening voor de buitenafvoer van de lucht uitsnijden. [. . . ] Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2 months). [. . . ]