User manual ROSIERES RHT625RB

[. . . ] - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through eiter a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnec t the elec trical plug prior to any maintenance. [. . . ] To fix it in place, use 4 screws which are suitable for the type of cabinet, making holes in accordance with the diagram shown in (fig. To fit the appliance correctly, align the front panel of the cooker hood - 18 - with the cabinet door and adjust spacer E using screws P (fig. 2), then ensure the appliance meets the cabinet at the rear. € Extraction through an outside wall The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange B (Fig 3). Remove the charcoal filters already fitted to the appliance by turning them 90° anticlockwise (Fig. € Recirculation The clean air is returned into the room through a connecting tube passing inside the cupboard and connected to the ring B (fig 4). The charcoal filters are already fitted to the appliance. If the telescopic undercarriage is closed the motor speeds cannot be activated. This microswitch does not have an impact on the activation of the lights which must be switched on through the appropriate switch (see fig. A = Light switch A1 = Off key A2 = On key B = Speed control B1 = FIRST SPEED key B2 = SECOND SPEED key B3 = THIRD SPEED ke Warning!If the telescopic undercarriage is closed with the speed set at 2, , once it is re-opened, the hood will be reactivated with the same speed in use when the hood was closed. To remove the incandescent light bulb, take out the grease filters as described in (Fig. Replace it with a new one of the same type (Fig. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. CUSTOMER ASSISTANCE SERVICE Before contacting the Technical Assistance Service: If the product does not operate at all, we advise you to: - check that the plug has been inserted into the power socket correctly. If you cannot identify the cause of the operating anomaly: switch off the appliance (do not subject it to rough treatment) and contact the Assistance Service. It is important that you inform the Assistance Service of your product code and its serial number (a 16-character code which begins with the number 3); this can be found on the guarantee certificate or on the data plate located inside the appliance. This will help to avoid wasted journeys being made by technicians, thereby (and most significantly) saving the corresponding callout charges. tHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE WARNINGS. [. . . ] 8) Slider the key symbols are explained below: This hood is fitted with a microswitch which allows the activation of the motor speed) through the opening of the - 19 - POLSC ČESKY ÚVOD’ Přečtěte si pozorně obsah návodu, protože poskytuje důležité informace týkající se bezpečné instalace, používání i údržby zařízení. For størst mulig sikkerhed, sørg for en passende ventilation af rummet. N dokumentasjonen viser til at dette produktet ikke må behandles som husholdningsavfall, men må leveres inn til spesialinnsamling for elektriske og elektroniske produkter for resirkulering. man må kvitte seg med apparatet slik lokale regler for avsetting og resirkulering tilsier. [. . . ]