User manual ROSIERES RHT650

[. . . ] If the appliance is equipped with power cord without plug, a suitably dimensioned omnipolar switch with 3 mm minimum opening between contacts must be fitted between the appliance and the electricity supply in compliance with the load and current regulations. - The connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral. € The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. [. . . ] F) Disconnect the electrical plug prior to any maintenance. G) This appliance is not intended for use by young children or infirm persons without supervision. H) Young children should be supervised to ensure they do not play with the appliance. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. L) There is a risk of fire if cleaning is not carried out in accordance with the instructions. This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a suitable manner, the user is helping to prevent potential damage to the environment or to public health. -9- • Fixing the hood to the lower part of the wall cabinet: This type of appliance must be fitted inside a cabinet or inside another type of support structure. To fix it in place, use 4 screws which are suitable for the type of cabinet, making holes in accordance with the diagram shown in Fig. To fit the appliance correctly, align the front panel of the cooker hood with the cabinet door and adjust spacer L using screws P (Fig. 2), then ensure the appliance meets the cabinet at the rear. € Extraction through an outside wall: The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange H (Fig. € Recirculation: To transform the cooker hood from the extraction version to the re circulating one ask your supplier for an activated carbon filter. The filter must be fitted to the extracting group cooker hood in the centre of the fan grille by twisting it by 90 degrees until it is gripped securely (Fig. For this operation remove the anti-grease filter(s) G (Fig. The clean air is returned into the room through a connecting tube passing inside the cupboard and connected to the ring H (Fig. One therefore recommends keeping to the suggested instructions. • Replacing halogen light bulbs (Fig. 6): To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. [. . . ] This does not give the right to claim their replacement. € The active carbon filters are used to purify the air that is sent back into the room and its function is to mitigate the unpleasant odours produced by cooking. - The non-regenerable active carbon filters must be replaced at least every 4 months. The saturation of the active charcoal depends on the more or less prolonged use of the appliance, on the type of kitchen and on the frequency with which antigrease filter is cleaned. [. . . ]