User manual ROSIERES RHTV680IN

[. . . ] - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through eiter a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnec t the elec trical plug prior to any maintenance. [. . . ] It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange B (Fig 3). Remove the charcoal filters already fitted to the appliance by turning them 90° anticlockwise (Fig. € Recirculation The clean air is returned into the room through a connecting tube passing inside the cupboard and connected to the ring B (fig 4). The charcoal filters are already fitted to the appliance. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Display C = indicates the motor speed level selected and activates the timer. Touching the key at 3rd speed, the intensive function runs for 10’, then the appliance go back to work at the original speed. During this function the display blinks. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. the Timer is deactivated by re-pressing Key E. When the Timer is activated the decimal point must flash on the display. The “clean air” function is activated by pressing key E for 2 seconds when the appliance is switched off. This switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary movement of the peripheral segments must be visualised on the display. When this time has passed the motor switches off and the fixed letter “C” must be visualised on the display until the motor re-starts after 50 minutes for another 10 minutes and so on. Press any key apart from the light keys to return to normal functioning. € Active carbon/grease filter saturation: - When display item C flashes, at a speed where it alternates with the letter F (e. 1 and F), the grease filters must be washed. - When display item C flashes, at a speed where it alternates with the letter A (e. 1 and A), the carbon filters must be replaced. After the clean filter has been positioned correctly, the electronic memory must be reset by pressing button A for approximately 5 seconds, until the indication F or A shown on the display C stops flashing. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. [. . . ] € The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended use of the light reduces the average duration of the bulb. The appliance switches on at speed level 1, If the cooker hood is on depress - 22 - ČESKY POLSC ÚVOD’ Přečtěte si pozorně obsah návodu, protože poskytuje důležité informace týkající se bezpečné instalace, používání i údržby zařízení. For størst mulig sikkerhed, sørg for en passende ventilation af rummet. [. . . ]