User manual ROSIERES RHV 911

[. . . ] 7 where the measurements for the various possibilities are indicated. For the electrical connection, follow all the other instructions on the "Warnings" sheet. Proceed with fixing the hood: Based on your requirements, you can fit the hood on the wall or on a wall unit of your kitchen. IMPORTANT: Respect the distance between the hob and lower part of the hood which must be at least 650 cm. [. . . ] mark the 4 holes to be drilled in the wall , respecting the distances indicated in Fig. 9; Make the 4 holes and fit the 4 screw anchors provided. 10G) and insert them in the topmost screw anchors without however screwing them down completely. hang the hood on the 2 screws; Working from inside the hood , tighten the 2 screws completely. Now proceed with final fixing by fitting the other 2 screws H (Fig. Fitting under wall unit: If you use the top opening B for the air outlet through the wall unit, before fixing the hood to the unit, drill a hole of 133 mm diameter in the wall unit (Fig. In any case, check the position of the power outlet and consider where the power cable will run, since a hole might have to be made in the wall unit to accommodate it. Push the hood up against the wall unit and insert the 4 screws operating from inside the wall unit (the 4 screws are not provided). CHECK THAT THE DUCTING-FILTERING LEVER IS IN THE RIGHT POSITION: The lever is found on the motor unit and must be positioned on the symbol (P) in the case of installation in ducting version (Fig. Also remember that the use of charcoal filters is not necessary with the ducting version; if these are fitted, remove them and proceed as following according to the model type purchased: - if the hood features round charcoal filters (Fig. 15A), remove the charcoal filter by first of all removing the two filter retainers M (the two filter retainers must then be fitted back on). Button B: drives the motor in first speed (the corresponding pilot lamp comes on); when holding it down for about 1", the motor cuts out. Button C: drives the motor in second speed (the corresponding pilot lamp comes on). Button D: drives the motor in third speed (the corresponding pilot lamp comes on). Button E: drives the motor in fourth speed (the corresponding pilot lamp comes on). Provision has been made to delay switching off of the hood to allow completion of ambient air purification. Starting from first speed, when pressing the current operating speed button (pilot lamp on), switching off will be delayed for 5'. 18): these are metal filters and must be periodically cleaned, approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. Wash the filters with neutral detergent. To remove the filters, in line with the handle, push the stop inwards and pull the filter down (Fig. 19N): this is a metal filter and is positioned inside the metal grid; the filter must be periodically cleaned, approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. To remove the filter, first of all remove the metal grid by pushing the two stops towards the inside of the hood (Fig. [. . . ] 20P): this filter is made of white synthetic fibres and is located inside the metal grid; it cannot be cleaned, but must be replaced approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. To remove the filter, first of all remove the metal grid, push the two stops towards the inside of the hood (Fig. 3); next, remove the two filter retainers inside the metal grid and remove the panel type synthetic filter. Charcoal filter/s: Replace the charcoal filter each time the light button lamp (Fig. [. . . ]