User manual ROSIERES RHV 994 IN

[. . . ] If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. 5-6 Disconnect the hood during electrical connection, by turning the home mains switch off. Rest the suction unit on a flat surface and thread the lower part of the hood onto it. [. . . ] Only if the control panel is already mounted on the lower flue: The pin of the small plate MUST correspond to the hole made in the connection plinth on the electronic box (20d). Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood. Fix the lower section of the chimney with two screws. Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply. Clean using the cloth dampened with neutral liquid detergent. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. Therefore we recommend observing these instructions. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. 2 This must be cleaned once a month (or when the filter saturation indication system ­ if envisaged on the model in possession ­ indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter B, pull the spring release handle. The charcoal filter can be washed once every two months (or when the filter saturation indication system ­ if envisaged on the model in possession ­ indicates this necessity) using hot water and a suitable detergent, or in a dishwasher at 65°C (if the dishwasher is used, select the full cycle function and leave dishes out). Eliminate excess water without damaging the filter, then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100° C to dry completely. Replace the mattress every 3 years and when the cloth is damaged. remove the filter holder frame by turning the knobs (g) 90° that affix the chimney to the cooker hood. Insert the pad (i) of activated carbon into the frame (h) and fit the whole back into its housing (j). It is possible to use a traditional carbon filter, neither washable nor regenerable, to be replaced every 3 - 4 months. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ]