User manual ROSIERES RHV912IN

[. . . ] - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. - This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating. B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. [. . . ] - Filtering version: Fix the flexible pipe to the deflector M and fix screw I as indicated in (Fig. - The charcoal filters are already fitted to the appliance (Fig. - Take the upper chimney piece and fix it to the structure using the 2 screws A (Fig. Join the lower chimney piece with the upper one and fix it carefully using adhesive tape L (Fig. Insert the suction unit inside the structure paying attention that the previously unscrewed screws O, hook into the slots in the lower part as indicated in (Fig. Drive in the 3 screws N (supplied) and tighten the 2 screws O (Fig. - Fix the air evacuation pipe H (not supplied) onto the connection flange F (Fig. - Remove adhesive tape L and rest the lower chimney piece above the cooker hood (Fig. - If the cooker hood is supplied with a lower chimney piece that must be fixed to the hood body with screws, remove the anti-grease filters from the hood by acting on the relevant handles (Fig. Then screw the lower chimney piece pipe to the inside of the hood, using screws P (Fig. Use of the light reduces the average duration of the bulb. • Replacing halogen light bulbs (Fig. 17): To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. 18): If the appliance version is with LED lamps, the intervention of a specialised technician is necessary to replace them. The “filter alarm” can be reset by pressing the button for a few seconds. Button B = Switches the appliance on/Decreases the extraction rate of the motor. If the speed of the cooker hood is set to 1, it switches off. The appliance can be switched off by pressing the “D” button for a few seconds. Automatic extraction function: With this function the appliance automatically adjusts the motor’s extraction rate according to the quality of the air below thanks to the sensor located under the cooker hood (Fig. To activate this function, press the “B” button for a few seconds. [. . . ] € Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, not-abrasive liquid detergents. € The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended - 13 - med and how often the anti-grease filters are cleaned. To activate the filter alarm function, press the “A+E“ buttons together. [. . . ]