User manual ROSIERES RHV9185IN

[. . . ] Clean air: La funzione clean air mette in funzione per 10 USO E MANUTENZIONE • Si raccomanda di mettere in funzione l’apparecchio prima di procedere alla cottura di un qualsiasi alimento. - 11 - ENGLISH GENERAL Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations. The appliance has been designed for use in the ducting version (air exhaust to the outside – Fig. [. . . ] Fix the lower flue to the hood using the screws B provided (Fig. 4), extract the upper flue up to the bracket and fix it with the screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. € Filtering version: Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. The charcoal filters are already fitted to the appliance (Fig. 9): If the appliance version is with LED lamps, the intervention of a specialised technician is necessary to replace them. The “filter alarm” can be reset by pressing the button for a few seconds. Button B = Switches the appliance on/Decreases the extraction rate of the motor. If the speed of the cooker hood is set to 1, it switches off. The appliance can be switched off by pressing the “D” button for a few seconds. Automatic extraction function: With this function the appliance automatically adjusts the motor’s extraction rate according to the quality of the air below thanks to the sensor located under the cooker hood (Fig. To activate this function, press the “B” button for a few seconds. The letter “S“ will appear on the display. When you switch on the cooker hood you will need to wait a few seconds, depending on the sensor’s setting, before the automatic extraction function is activated. If the function has not been activated yet, there will be a decimal point flashing on the display. Setting the sensor: According to the type of hob (gas or electric) it is possible to increase the effectiveness of the sensor by matching the cooker hood with the right hob. To carry out this operation, press the “B” and “D” buttons together for a few seconds with the motor off. - To match the cooker hood with a gas hob, press the “B“ button. a “P” and a “0” will alternate on the display. - To match the cooker hood with an electric hob, press the “D“ button. a “P” and a “1” will alternate on the display. [. . . ] This does not mean they have to be replaced. If the replacement and washing instructions are not followed, the anti-grease filters may present a fire hazard. € The active carbon filters are used to purify the air which is released back into the room. The filters are not washable or re-usable and must be replaced at least once every four months. [. . . ]