User manual ROSIERES RTV 640 PL

[. . . ] Both the worktop where the hob will be fitted and any adjacent kitchen furniture must be made from heat resistant material and fixed with heat resistant adhesive. If, when installing the hob, the lower hob face is adjacent to an area normally accessible when handling or cleaning, fit a heatproof partition 1 cm below the base of the hob with a 10X10 cm opening at the rear right-hand corner, to avoid any risk of scorching or damage. a foam adhesive is supplied with the hob. Stick this seal under the edge of the body as near as possible to the outer edge of the hob. [. . . ] Warning : never losen the others screws!Each burner is contolled by a tap with progressive settings allowing: * a wider choice of settings from the maximum position to the lowest and most precise one, * easier flame regulation according to the pan diameter, * no risk of cutting off the flame or switching off when the flame is turned down quickly. IGNITION RECOMMENDATIONS : when the burners are not in service, the general gas supply tap should always be turned off. A symbol next to each control knob indicates which burner is lit. ⷠTurn and press in the relevant burner control knob to the symbol, keeping it pressed in until the flame ignites. on models fitted with electronic ignition the flame is ignited by an electric spark. This is operated by the button or by pressing the knob (for models with ignition under the knob). For models not fitted with electronic ignition, or if there is no electric power, light the flame with a match. NB: for models fitted with the SAFETY thermocouple, keep the knob pressed in for a few seconds in order to activate the safety system. If the knob is released straightaway there is not time for the safety system to be activated and the flame goes out. If this happens, repeat the ignition procedure from the beginning waiting longer after the flame is lit. The rapid thermocouple safety device automatically cuts off the gas supply if the flame is accidentally extinguished. If there are particular local gas supply conditions which make ignition difficult, you are advised to repeat the ignition procedure, turning the knob to "minimum" ( ). ⷠSet the flame according to your cooking requirements. Intermediate positions are available between the maximum and minimum settings on the control knob. ⷠTo turn the flame out, turn the control knob back to stop position. ⷠIf the burner is accidentally extinguished, turn the knob to "0", wait one minute and then try to ignite again. PANS For a proper use of the burners, choose pans which match the dimensions given below : BURNER TYPE PANS DIAMETERS --------------------------------------------------------------ULTRA RAPID 24 - 26 cm RAPID 18 - 24 cm SEMI-RAPID 12 - 18 cm AUXILIARY 10 - 18 cm · Pans with curved, ridged or warped bottoms are not recommended. These marks can easily be removed with a damp cloth and a light abrasive product. Before carrying out any cleaning, you must : · Disconnect the appliance from the electrical supply and wait for all the hot parts to cool. ⷠNever use abrasive cleaners, wire wool or sharp objects to clean the appliance. ⷠIt is advisable to keep away from the hob all substances which are liable to melt, such as plastic items, sugar, or sugarbased products. [. . . ] ⷠTo save gas, make sure that the flames do not overlap the bottom of the pan. ⷠDo not use the gas burner with an empty pan. Before calling out a Service Engineer please check the following: -- that the plug is correctly inserted and fused; If the fault cannot be identified: switch off the appliance -- do not tamper with it -- call the Aftercare Service Centre. The appliance is supplied with a guarantee certificate that ensures that it will be repaired free of charge at the Service Centre. [. . . ]