User manual ROSIERES TC 04

[. . . ] The mains electricity supply connected to the appliance should comply with the norms in force in the country of installation. Rosières declines all responsibility for any damage that may be caused by unsuitable or unreasonable use. warning : · Always check before any electrical operation, the supply voltage shown on the electricity meter, the adjustment of the circuit-breaker, the continuity of the connection to earth of the installation and that the fuse is suitable. [. . . ] If, when installing the hob, the lower part of the casing is adjacent to an area normally accessible when handling or cleaning, fit a heatproof partition 1 cm below the base of the casing, with a 10 x 10 cm opening in the rear right-hand corner, to avoid any risk of burning or damage. There should also be a 5 cm gap between the appliance and all adjacent vertical surfaces. a foam adhesive seal is supplied with the hob. Stick this seal under the edge of the body as near as possible to the outer edge of the hob. Press round the edges of the hob, so that the seal flattens out and ensures an air tight seal. The body of the hob is fitted with 4 location holes to take the fixing brackets that secure the intended to fix the hob in the unit. Place the 4 fixing brackets in such a way that the hob surface is placed perfectly in the support unit. In order to improve the quality of the products, ROSIERES may carry out modifications linked to technical improvements. Each position corresponds to a permanent and progressive temperature according to the marks 1, 2, 3, 4, 5 and 6. rAPID SELF-PROTECTING ELECTRIC HOT PLATE (with a red dot in the centre) This is a cast-iron hot plate , controlled by a 7 position switch. As with the previous hot plate, each position corresponds to a permanent and progressive temperature according to the marks 1, 2, 3, 4, 5 and 6. An internal thermostat cuts off of the power supply if there is any overheating. (If, for example, a hot plate is working without a pan on it). bEFORE USING THE ELECTRIC HOT PLATE : · Before using the electric hot plate for the first time, let it heat up for a few minutes, without a pan, at maximum temperature to let the protective coating harden. hOW TO USE : · For best results, it is advisable to start on the maximum heat and then turn back to an intermediate temperature taking into account the type and volume of the food. To stop it, turn back the knob until position " ". [. . . ] THE KNOBS For thorough cleaning, the control knobs can be removed by pulling them upwards. Clean exclusively with soapy water and dry well before replacing them. THE HOT PLATE Heat it for a while if necessary, to burn the deposits. [. . . ]