User manual ROSIERES TSS 400-1

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ROSIERES TSS 400-1. We hope that this ROSIERES TSS 400-1 user guide will be useful to you.

Lastmanuals help download the user guide ROSIERES TSS 400-1.


Mode d'emploi ROSIERES TSS 400-1
Download
Manual abstract: user guide ROSIERES TSS 400-1

Detailed instructions for use are in the User's Guide.

[. . . ] Please note : if there is a power cut, the burner can be ignited by pressing in and turning the knob to position "+" and holding a naked flame to the burner. RECOMMENDATION : When the burners are not being used the mains gas supply valve should be closed. THE RAPID DOUBLE RING BURNER 3, 2 kW 3200 watts utilised on two burner rings of flames which ensure a best heat dissipation on the pan base. [. . . ] If you clean the enamelled parts when they are hot, you may tarnish them. THE STAINLESS STEEL PARTS To clean the stainless steel parts, use one the special cleaning products that are readily available in the shops. UNPACKING THE HOB : you will find the small bag containing the injectors, the fixing screw, and the clips. Both the unit into which the hob will be fitted and any adjacent kitchen furniture must be made of heat resistant material and fixed with heat resistant adhesive. A panel must be placed at least 1 cm minimum below the hob unit in order to allow the adequate circulation of the air around. Take care to keep a minimum 5 cm space between the appliance and the nearby kitchen units. a foam adhesive seal is supplied with the hob. Stick this seal under the edge of the body as near as possible to the outer edge of the hob. Press round the edges of the hob, so that the seal flattens out and ensures an air tight seal. When placing the hob in the cut-out section, try to push it as far as possible to the edging side. the hob is then centred in relation to the cut-out. The body of the hob is fitted with 4 location holes to take the fixing bars intended to fix the hob in the unit. Place the 4 fixing bars in such a way that the hob surface is placed perfectly in the support unit. It is recommended that the fixing holes not used are blanked off with the fixing screws. Warning : at the rear of the appliance, take care not to choke the air outlets necessary to the combustion. The following technical instructions are intended for installers. [. . . ] connect the hob on a plug with 10/16 A. Before connecting, it is compulsory to check the line voltage indicated on the electrical meter, circuit breaker rating, and the calibre of the fuse 10 A. Warning : always check the continuity of the connection to the installation before any electrical operation. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ROSIERES TSS 400-1

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ROSIERES TSS 400-1 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag