User manual ROSIERES V 45

[. . . ] 3), the appliance must be connected to an ducting apparatus/motor which works on its own using the appliance as a union for the air to be scavenged. use only motors proposed in the original catalogue. According to the model you have bought, the appliance can include 1 or 2 motors. [. . . ] 4): pull the front of the grille upwards; desinsert the back from its seat. IMPORTANT: So as not to damage your product, during installation USE ONLY THE SCREWS PROVIDED. Make sure these are used as shown in the following instructions. To compensate possible depth voids between the appliance and the wall, a plastic SPACING BAR to be fixed at the back of the appliance by means of the three screws A is included (Fig. Cut the spacing bar according to the distance to be adjusted. ASSEMBLY UNDER A PENSILE CUPBOARD: The following operations are essential for assembly: ­ Install the wiring system; ­ Prepare the air venting hole if your appliance is to be installed in the ducting version or in the version with an external motor. In the Ducting version and in the version with an External motor, to get optimal conditions the air venting pipe should: ­ be as short as possible. It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 125 mm). 9: Switch C: position A (automatic), the motor and the light are automatically regulated ON or OFF by the opening/closing of the telescopic slide; position M (manual), the light is on; position 0, the light is off. switch B: it select the speed of the motor. Opening the truck, the motor works automatically at the last working speed. 10: Switch D: position A (automatic), the motor and the light are automatically regulated ON or OFF by the opening/closing of the telescopic slide; position M (manual), the light is on; position 0, the light is off. Opening slightly the telescopic slide, the motor works at the I speed; opening a bit more, the motor works at the II speed; opening totally the telescopic slide, the motor works at the III speed. With switch C in position M the motor will operate automatically when the telescopic slide is pulled out; position T (total): permits automatic on/off use of both the motor and the lights; position L: permits use of the lights with the motor off. Switch B: controls the speed of the motor; when the switch is in M or T position, opening the telescopic slide, the motor starts working automatically at the selected speed. Particular care must be paid to the grease grille which must be periodically cleaned in relation to use (at least once every Remove the grease grille and wash them either by hand or in the dishwasher using neutral detergent. [. . . ] In case the hood is a filtering version one, it is necessary to change the activated charcoal fiber panel according to utilization about every six month. ­ take off the anti-grease grill: pull the front of the grille upwards; desinsert the back from its seat. ­ take off the fiber panel from the inside of the anti-grease grille taking off the 2 metal wires F (Fig. [. . . ]