User manual ROSIERES VE 75

[. . . ] 6, R1) and two dowels in the lower drill holes outlet or directly in place of the connection ring (G3 with one (Fig. 6, R2), fasten the lower bracket to the wall with two screw), for discharging of fumes above the cabinet. 6, Q), hang the cooker hood on the wall, If necessary, a small tube trunk equivalent to the connection regulate the position of the cooker hood (Fig. 6 - screws S1 ring is mounted in order to reach above the cabinet, the for vertical regulation, screws S2 for depth regulation), deflector (if supplied) is then affixed to the hole cut out on the place connection ring and discharge pipe (or deflector if top of the cabinet for the discharging of fumes. [. . . ] The models supplied) to the cooker hood outlet (see "Use" section), without suction motor function only in the suction version fasten the cooker hood to the lower bracket (Fig. 6, Q) with and must be connected to an external suction unit (not two screws and plastic washers (Fig. Access to the screws that secure the lower bracket may be through the drill holes located inside the cooker hood Installation: Do not tile, grout or silicone this appliance to (Fig. The cooker hood must be positioned at a minimum distance to the cooktop of 65 cm Electrical connection: The electrical tension must correspond to the tension noted on the label placed inside for electric top cookers and 70 cm for mixed or gas top the cooker hood. connect the electrical plug , where cookers. The cooker hood may be installed directly to the provided, to the an easily accessible outlet in conformity wall or between hanging cabinets (see mounting diagram). Where an electrical plug is not The vapour collector must be covered with an aesthetic provided (for direct connection to electrical network) place covering panel. a standards approved bipolar switch with an aperture Affixing the aesthetic panel - Fig. 3, remove the suction distance of not less than 3mm (accessible) from the contacts. 1), depending on the model turn the lateral Caution: This appliance is designed to be operated by handles and remove the grill by sliding towards the bottom adults. switch via opening and closing the vapour collector. For cleaning use a cloth moistened with neutral liquid Use the higher suction speed for higher concentration of detergents. It is recommended to operate the cooker Failure to carry out the basic standards of the hood suction 5 minutes prior to cooking and leave it in cleaning of the cooker hood and replacement of the operation for approximately 15 minutes after cooking. Therefore we recommend Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the electrical outlet. anti-grease Filter Traps cooking grease particles. If situated inside the grill support, it may be one of the following types: Paper filter must be replaced once a month or sooner, if coloured on the upper side, when the coloration is visible through the grill holes. Sponge filter should be washed in soapy water monthly and replaced every 5/6 washes. Metallic filter must be cleaned once a month by hand using non abrasive detergents or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. Some models are provided with anti-grease filter incorporated in the suction grill, these should be removed from the housing by pulling the handles upwards and sliding out (Fig. [. . . ] When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. Some models are provided with anti-grease filter incorporated in the suction grill, these should be removed from the housing by pulling the handles upwards and sliding out (Fig. 2, H2-H3-H4), wash these filters as with metallic filters. Carbon Filter (Filter Version only) The active carbon filter is not washable nor reusable. [. . . ]