User manual ROSIERES VE 76

[. . . ] It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 150 mm). For air evacuation to the outside, follow all the other instructions given on the "Warnings" sheet. Prepare the power supply within the telescopic chimney (for the electrical connection, follow all the other instructions on the "Warnings" sheet). As previously specified in the chapter "Warning" remember there must be a minimum of 650 mm between the bottom edge of the hood and the stop of the stove. [. . . ] As previously specified in the chapter "Warning" remember there must be a minimum of 650 mm between the bottom edge of the hood and the stop of the stove. Secure the metal bracket (A) to the wall using the screws and plugs (bracket, screws and plugs are all supplied with the unit). Use the 2 triangles cut into the bracket to position it precisely along the vertical axis of the hood. Then set the hood onto the bracket (Fig. Adjust the horizontal position, shifting the hood to the right or left as needed lining it up with the wall units. If the height of the hood also requires adjustment, use the special regulation screws (B) (supplied). Once regulation has been completed, finish securing the hood with 4 more screws (C): mark the points for the 4 holes on the wall, remove the hood and drill (8mm diameter holes); then use the plugs and screws to complete installation. Rest the lower edge of the panel behind the stove and anchor the upper edge to the wall using the two holes found on the panel. insert the screws and plugs provided (A). The unit is secured to the rear panel as though it were being installed on the wall: use the supplied metal bracket (B) and the screws and plugs supplied with the panel. To restart the hour counter (RESET), hold the button A pressed down for about 1" (while the pilot lamp S is on). Button B: drives the motor in first speed (the corresponding pilot lamp comes on); when holding it down for about 1", the motor cuts out. Button C: drives the motor in second speed (the corresponding pilot lamp comes on). Button D: drives the motor in third speed (the corresponding pilot lamp comes on). Button E: drives the motor in fourth speed (the corresponding pilot lamp comes on). Provision has been made to delay switching off of the hood to allow completion of ambient air purification. Starting from 2nd speed, when pressing the current operating speed button (pilot lamp on), switching off will be delayed for 5'. during this period the pilot lamp flashes. Pay special attention to the grease filters: the metal grease filters must be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. [. . . ] Pay special attention to the grease filters: the metal grease filters must be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. Wash out the filter using a neutral soap. Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1" (Fig. [. . . ]