User manual ROTEL RB-956AX

[. . . ] RB-951 MkII POWER CONSUMPTION: 200W BRIDGED MONO NORMAL STERO BRIDGED SIGNAL OUTPUT LINK RB-951 MkII 5 English WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. [. . . ] Use only this cord or an exact equivalent. A heavy duty multi-tap power outlet strip may be used, but only if it is rated to handle the current demanded by the RB-951MkII. Be sure the power switch on the front panel of the RB-951MkII is turned off. Then, plug one end of the cord into the AC power connector on the back panel of the amplifier. Plug the other end into an appropriate AC outlet. Your RB-951MkII is configured at the factory for the proper AC line voltage in the country where you purchased it (USA: 115 volts/60 Hz , Europe: 230 volts/50 Hz). The AC line configuration is noted on a label on the back panel. A Few Precautions Please read this manual carefully. In addition to basic installation and operating instructions, it provides valuable information on various RB-951MkII system configurations as well as general information that will help you get optimum performance from your system. Please contact your authorized Rotel dealer for answers to any questions you might have. In addition, all of us at Rotel welcome your questions and comments. Save the RB-951MkII shipping carton and all enclosed packing material for future use. These allow you to adjust the gain of the amplifier to match other components in an elaborate system. The CH1 level control changes the gain of the left channel; the CH2 level control changes the right channel. To adjust these controls, use a small, flat-blade screwdriver. Turn the control clockwise to increase gain. Turn counterclockwise to reduce gain. These controls may be disabled by resetting an internal jumper. NOTE: 9 English If you are using banana plugs, connect them to the wires and then plug into the backs of the speaker connectors. The collars of the speaker connectors should be screwed in all the way (clockwise). If you are using terminal lugs, connect them to the wires. If you are attaching bare wires directly to the speaker connectors, separate the wire conductors and strip back the insulation from the end of each conductor. Be careful not to cut into the wire strands. Unscrew (turn counterclockwise) the speaker connector collar. Place the connector lug around the shaft, or insert the bundled wire into the hole in the shaft. [. . . ] Check AC power connections at the amplifier and the AC outlet. Make sure that it is set to the ON position. If using signal sensing auto power-on, make sure that a signal is present at the inputs. If using 12V trigger power-on, make sure that a trigger signal is present at rear panel screw terminals. After removing the top cover, the jumper blocks can be found on the circuit board as shown in Figure 1. [. . . ]